[lkml]   [2019]   [Mar]   [13]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH v4 03/10] of/irq: document properties for wakeup interrupt parent
Some interrupt controllers in a SoC, are always powered on and have a
select interrupts routed to them, so that they can wakeup the SoC from
suspend. Add wakeup-parent DT property to refer to these interrupt

If the interrupts routed to the wakeup parent are not sequential, than a
map needs to exist to associate the same interrupt line on multiple
interrupt controllers. Providing this map in every driver is cumbersome.
Let's add this in the device tree and document the properties to map the
interrupt specifiers

Signed-off-by: Lina Iyer <>
Changes in v4:
- Added this documentation
.../interrupt-controller/interrupts.txt | 39 +++++++++++++++++++
1 file changed, 39 insertions(+)

diff --git a/Documentation/devicetree/bindings/interrupt-controller/interrupts.txt b/Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
index 8a3c40829899..917b598317f5 100644
--- a/Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
+++ b/Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
@@ -108,3 +108,42 @@ commonly used:
sensitivity = <7>;
+3) Interrupt wakeup parent
+Some interrupt controllers in a SoC, are always powered on and have a select
+interrupts routed to them, so that they can wakeup the SoC from suspend. These
+interrupt controllers do not fall into the category of a parent interrupt
+controller and can be specified by the "wakeup-parent" property and contain a
+single phandle referring to the wakeup capable interrupt controller.
+ Example:
+ wakeup-parent = <&pdc_intc>;
+4) Interrupt mapping
+Sometimes interrupts may be detected by more than one interrupt controller
+(depending on which controller is active). The interrupt controllers may not
+be in hierarchy and therefore the interrupt controller driver is required to
+establish the relationship between the same interrupt at different interrupt
+controllers. If these interrupts are not sequential then a map needs to be
+specified to help identify these interrupts.
+Mapping the interrupt specifiers in the device tree can be done using the
+"irqdomain-map" property. The property contains interrupt specifier at the
+current interrupt controller followed by the interrupt specifier at the mapped
+interrupt controller.
+ irqdomain-map = <incoming-interrupt-specifier mapped-interrupt-specifier>
+The optional properties "irqdomain-map-mask" and "irqdomain-map-pass-thru" may
+be provided to help interpret the valid bits of the incoming and mapped
+interrupt specifiers respectively.
+ Example:
+ irqdomain-map = <22 0 &intc 36 0>, <24 0 &intc 37 0>;
+ irqdomain-map-mask = <0xff 0>;
+ irqdomain-map-pass-thru = <0 0xff>;
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum,
a Linux Foundation Collaborative Project
 \ /
  Last update: 2019-03-13 22:19    [W:0.154 / U:3.608 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site