lkml.org 
[lkml]   [2019]   [Feb]   [2]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
Date
From
SubjectRe: [PATCH v3 12/13] dt-bindings: spi: atmel-quadspi: QuadSPI driver for Microchip SAM9X60
On Sat, 2 Feb 2019 04:07:44 +0000
<Tudor.Ambarus@microchip.com> wrote:

> From: Tudor Ambarus <tudor.ambarus@microchip.com>
>
> The sam9x60 qspi controller uses 2 clocks, one for the peripheral register
> access, the other for the qspi core and phy. Both are mandatory.
>
> Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>

Reviewed-by: Boris Brezillon <bbrezillon@kernel.org>

> ---
> v3: "pclk" was made mandatory in previous patch. Reword clock
> descriptions.
> v2:
> - make "pclk" mandatory even for sama5d2. Unnamed clk will be
> supported in the driver.
> - drop unneeded example
>
> Documentation/devicetree/bindings/spi/atmel-quadspi.txt | 10 +++++++---
> 1 file changed, 7 insertions(+), 3 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/spi/atmel-quadspi.txt b/Documentation/devicetree/bindings/spi/atmel-quadspi.txt
> index 1de54e87f5d6..fc7e83adab36 100644
> --- a/Documentation/devicetree/bindings/spi/atmel-quadspi.txt
> +++ b/Documentation/devicetree/bindings/spi/atmel-quadspi.txt
> @@ -1,15 +1,19 @@
> * Atmel Quad Serial Peripheral Interface (QSPI)
>
> Required properties:
> -- compatible: Should be "atmel,sama5d2-qspi".
> +- compatible: Should be one of the following:
> + - "atmel,sama5d2-qspi"
> + - "microchip,sam9x60-qspi"
> - reg: Should contain the locations and lengths of the base registers
> and the mapped memory.
> - reg-names: Should contain the resource reg names:
> - qspi_base: configuration register address space
> - qspi_mmap: memory mapped address space
> - interrupts: Should contain the interrupt for the device.
> -- clocks: The phandle of the clock needed by the QSPI controller.
> -- clock-names: Should contain "pclk" for the peripheral clock.
> +- clocks: Should reference the peripheral clock and the QSPI system
> + clock if available.
> +- clock-names: Should contain "pclk" for the peripheral clock and "qspick"
> + for the system clock when available.
> - #address-cells: Should be <1>.
> - #size-cells: Should be <0>.
>

\
 
 \ /
  Last update: 2019-02-02 08:19    [W:0.166 / U:1.628 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site