lkml.org 
[lkml]   [2019]   [Feb]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4/4] NTB: ntb_hw_amd: set peer limit register
Date
From: Sanjay R Mehta <sanju.mehta@amd.com>

As per amd ntb spec it says that peer limit register
must be programmed

Signed-off-by: Sanjay R Mehta <sanju.mehta@amd.com>
---
drivers/ntb/hw/amd/ntb_hw_amd.c | 8 ++++----
1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/ntb/hw/amd/ntb_hw_amd.c b/drivers/ntb/hw/amd/ntb_hw_amd.c
index efb214f..cd463e1 100644
--- a/drivers/ntb/hw/amd/ntb_hw_amd.c
+++ b/drivers/ntb/hw/amd/ntb_hw_amd.c
@@ -160,8 +160,8 @@ static int amd_ntb_mw_set_trans(struct ntb_dev *ntb, int pidx, int idx,
}

/* set and verify setting the limit */
- write64(limit, mmio + limit_reg);
- reg_val = read64(mmio + limit_reg);
+ write64(limit, peer_mmio + limit_reg);
+ reg_val = read64(peer_mmio + limit_reg);
if (reg_val != limit) {
write64(base_addr, mmio + limit_reg);
write64(0, peer_mmio + xlat_reg);
@@ -183,8 +183,8 @@ static int amd_ntb_mw_set_trans(struct ntb_dev *ntb, int pidx, int idx,
}

/* set and verify setting the limit */
- writel(limit, mmio + limit_reg);
- reg_val = readl(mmio + limit_reg);
+ writel(limit, peer_mmio + limit_reg);
+ reg_val = readl(peer_mmio + limit_reg);
if (reg_val != limit) {
writel(base_addr, mmio + limit_reg);
writel(0, peer_mmio + xlat_reg);
--
2.7.4
\
 
 \ /
  Last update: 2019-02-15 10:22    [W:0.039 / U:4.140 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site