lkml.org 
[lkml]   [2019]   [Feb]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 05/11] mfd: pm8xxx: disassociate old virq if hwirq mapping already exists
From
Date
Quoting Brian Masney (2019-02-07 18:16:25)
> Check to see if the hwirq is already associated with another virq on
> this IRQ domain. If so, then disassociate it before associating the
> hwirq with the new virq.
>
> This is a temporary hack that is needed in order to not break git
> bisect for existing boards. The next patch in this series converts
> ssbi-gpio to be a hierarchical IRQ chip, then there are several patches
> to update all of the device tree files, and finally this patch will be
> reverted within the same patch series.
>
> IRQs for ssbi-gpio are all initially setup without an IRQ hierarchy
> this driver is probed due to the interrupts property in device tree.
> Once ssbi-gpio is converted to be a hierarchical IRQ chip in the next
> patch, existing users of gpio[d]_to_irq() will call pmic_gpio_to_irq(),
> and that will use the new IRQ chip code in ssbi-gpio that sets up the
> IRQ in an IRQ hierarchy. The hwirq is now associated with two Linux
> virqs and interrupts will not work as expected. This patch corrects
> that issue.
>
> This change was tested on an APQ8060 DragonBoard.
>
> Signed-off-by: Brian Masney <masneyb@onstation.org>
> Tested-by: Linus Walleij <linus.walleij@linaro.org>
> ---
> Changes since v1:
> - None
>
> drivers/mfd/qcom-pm8xxx.c | 6 ++++++
> 1 file changed, 6 insertions(+)
>
> diff --git a/drivers/mfd/qcom-pm8xxx.c b/drivers/mfd/qcom-pm8xxx.c
> index 8eb2528793f9..2f99a98ccee5 100644
> --- a/drivers/mfd/qcom-pm8xxx.c
> +++ b/drivers/mfd/qcom-pm8xxx.c
> @@ -380,6 +380,12 @@ static void pm8xxx_irq_domain_map(struct pm_irq_chip *chip,
> struct irq_domain *domain, unsigned int irq,
> irq_hw_number_t hwirq, unsigned int type)
> {
> + unsigned int old_virq;
> +
> + old_virq = irq_find_mapping(domain, hwirq);
> + if (old_virq)
> + irq_domain_disassociate(domain, old_virq);

Is it possible to pass 'true' for the 'realloc' argument to
__irq_domain_alloc_irqs() and then this disassociate change isn't
needed?

> +
> irq_domain_set_info(domain, irq, hwirq, chip->pm_irq_data->irq_chip,
> chip, handle_level_irq, NULL, NULL);
> irq_set_noprobe(irq);

\
 
 \ /
  Last update: 2019-02-15 06:52    [W:0.153 / U:4.224 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site