lkml.org 
[lkml]   [2019]   [Dec]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH 0/2] PCI: amlogic: Make PCIe working reliably on AXG platforms
Date

On Sun 08 Dec 2019 at 22:03, Remi Pommarel <repk@triplefau.lt> wrote:

> PCIe device probing failures have been seen on some AXG platforms and were
> due to unreliable clock signal output. Setting HHI_MIPI_CNTL0[26] bit
> solved the problem. After being contacted about this, vendor reported that
> this bit was linked to PCIe PLL CML output.

Thanks for reporting the problem.

As Martin pointed out, the CML outputs already exist in the AXG clock
controller but are handled using HHI_PCIE_PLL_CNTL6. Although
incomplete, it seems to be aligned with the datasheet I have (v0.9)

According to the same document, HHI_MIPI_CNTL0 belong to the MIPI Phy.
Unfortunately bit 26 is not documented

AFAICT, the clock controller is not appropriate driver to deal with this
register/bit

>
> This serie adds a way to set this bit through AXG clock gating logic.
> Platforms having this kind of issue could make use of this gating by
> applying a patch to their devicetree similar to:
>
> clocks = <&clkc CLKID_USB
> &clkc CLKID_MIPI_ENABLE
> &clkc CLKID_PCIE_A
> - &clkc CLKID_PCIE_CML_EN0>;
> + &clkc CLKID_PCIE_CML_EN0
> + &clkc CLKID_PCIE_PLL_CML_ENABLE>;
> clock-names = "pcie_general",
> "pcie_mipi_en",
> "pcie",
> - "port";
> + "port",
> + "pll_cml_en";
> resets = <&reset RESET_PCIE_PHY>,
> <&reset RESET_PCIE_A>,
> <&reset RESET_PCIE_APB>;

A few remarks for your future patches:

* You need to document any need binding you introduce:
It means that there should have been a patch in
Documentation/devicetree/... before using your newclock name in the
pcie driver. As Martin pointed out, dt-bindings should be dealt with
in their own patches

>
>
> Remi Pommarel (2):
> clk: meson: axg: add pcie pll cml gating

Whenever possible, patches intended for different maintainers should be
sent separately (different series)

> PCI: amlogic: Use PCIe pll gate when available
>
> drivers/clk/meson/axg.c | 3 +++
> drivers/clk/meson/axg.h | 2 +-
> drivers/pci/controller/dwc/pci-meson.c | 5 +++++
> include/dt-bindings/clock/axg-clkc.h | 1 +
> 4 files changed, 10 insertions(+), 1 deletion(-)

\
 
 \ /
  Last update: 2019-12-09 09:33    [W:0.076 / U:0.848 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site