lkml.org 
[lkml]   [2019]   [Dec]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH 0/2] PCI: amlogic: Make PCIe working reliably on AXG platforms
Date
PCIe device probing failures have been seen on some AXG platforms and were
due to unreliable clock signal output. Setting HHI_MIPI_CNTL0[26] bit
solved the problem. After being contacted about this, vendor reported that
this bit was linked to PCIe PLL CML output.

This serie adds a way to set this bit through AXG clock gating logic.
Platforms having this kind of issue could make use of this gating by
applying a patch to their devicetree similar to:

clocks = <&clkc CLKID_USB
&clkc CLKID_MIPI_ENABLE
&clkc CLKID_PCIE_A
- &clkc CLKID_PCIE_CML_EN0>;
+ &clkc CLKID_PCIE_CML_EN0
+ &clkc CLKID_PCIE_PLL_CML_ENABLE>;
clock-names = "pcie_general",
"pcie_mipi_en",
"pcie",
- "port";
+ "port",
+ "pll_cml_en";
resets = <&reset RESET_PCIE_PHY>,
<&reset RESET_PCIE_A>,
<&reset RESET_PCIE_APB>;


Remi Pommarel (2):
clk: meson: axg: add pcie pll cml gating
PCI: amlogic: Use PCIe pll gate when available

drivers/clk/meson/axg.c | 3 +++
drivers/clk/meson/axg.h | 2 +-
drivers/pci/controller/dwc/pci-meson.c | 5 +++++
include/dt-bindings/clock/axg-clkc.h | 1 +
4 files changed, 10 insertions(+), 1 deletion(-)

--
2.24.0

\
 
 \ /
  Last update: 2019-12-08 21:55    [W:0.059 / U:4.112 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site