lkml.org 
[lkml]   [2019]   [Dec]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] net: stmmac: reset Tx desc base address before restarting Tx
Date
Refer to the databook of DesignWare Cores Ethernet MAC Universal:

6.2.1.5 Register 4 (Transmit Descriptor List Address Register

If this register is not changed when the ST bit is set to 0, then
the DMA takes the descriptor address where it was stopped earlier.

The stmmac_tx_err() does zero indices to Tx descriptors, but does
not reset HW current Tx descriptor address. To fix inconsistency,
the base address of the Tx descriptors should be rewritten before
restarting Tx.

Signed-off-by: Jongsung Kim <neidhard.kim@lge.com>
---
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 2 ++
1 file changed, 2 insertions(+)

diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 644cb5d1fd4f..bbc65bd332a8 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -2009,6 +2009,8 @@ static void stmmac_tx_err(struct stmmac_priv *priv, u32 chan)
tx_q->cur_tx = 0;
tx_q->mss = 0;
netdev_tx_reset_queue(netdev_get_tx_queue(priv->dev, chan));
+ stmmac_init_tx_chan(priv, priv->ioaddr, priv->plat->dma_cfg,
+ tx_q->dma_tx_phy, chan);
stmmac_start_tx_dma(priv, chan);

priv->dev->stats.tx_errors++;
--
2.20.1
\
 
 \ /
  Last update: 2019-12-06 13:10    [W:0.033 / U:29.020 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site