lkml.org 
[lkml]   [2019]   [Dec]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 5.3 095/135] iavf: initialize ITRN registers with correct values
Date
From: Nicholas Nunley <nicholas.d.nunley@intel.com>

[ Upstream commit 4eda4e0096842764d725bcfd77471a419832b074 ]

Since commit 92418fb14750 ("i40e/i40evf: Use usec value instead of reg
value for ITR defines") the driver tracks the interrupt throttling
intervals in single usec units, although the actual ITRN registers are
programmed in 2 usec units. Most register programming flows in the driver
correctly handle the conversion, although it is currently not applied when
the registers are initialized to their default values. Most of the time
this doesn't present a problem since the default values are usually
immediately overwritten through the standard adaptive throttling mechanism,
or updated manually by the user, but if adaptive throttling is disabled and
the interval values are left alone then the incorrect value will persist.

Since the intended default interval of 50 usecs (vs. 100 usecs as
programmed) performs better for most traffic workloads, this can lead to
performance regressions.

This patch adds the correct conversion when writing the initial values to
the ITRN registers.

Signed-off-by: Nicholas Nunley <nicholas.d.nunley@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
drivers/net/ethernet/intel/iavf/iavf_main.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/net/ethernet/intel/iavf/iavf_main.c b/drivers/net/ethernet/intel/iavf/iavf_main.c
index 9d2b50964a08f..fa857b60ba2b6 100644
--- a/drivers/net/ethernet/intel/iavf/iavf_main.c
+++ b/drivers/net/ethernet/intel/iavf/iavf_main.c
@@ -336,7 +336,7 @@ iavf_map_vector_to_rxq(struct iavf_adapter *adapter, int v_idx, int r_idx)
q_vector->rx.target_itr = ITR_TO_REG(rx_ring->itr_setting);
q_vector->ring_mask |= BIT(r_idx);
wr32(hw, IAVF_VFINT_ITRN1(IAVF_RX_ITR, q_vector->reg_idx),
- q_vector->rx.current_itr);
+ q_vector->rx.current_itr >> 1);
q_vector->rx.current_itr = q_vector->rx.target_itr;
}

@@ -362,7 +362,7 @@ iavf_map_vector_to_txq(struct iavf_adapter *adapter, int v_idx, int t_idx)
q_vector->tx.target_itr = ITR_TO_REG(tx_ring->itr_setting);
q_vector->num_ringpairs++;
wr32(hw, IAVF_VFINT_ITRN1(IAVF_TX_ITR, q_vector->reg_idx),
- q_vector->tx.target_itr);
+ q_vector->tx.target_itr >> 1);
q_vector->tx.current_itr = q_vector->tx.target_itr;
}

--
2.20.1


\
 
 \ /
  Last update: 2019-12-04 00:10    [W:0.417 / U:18.740 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site