lkml.org 
[lkml]   [2019]   [Dec]   [26]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v3 0/5] PCI: amlogic: Make PCIe working reliably on AXG platforms
Date

On Tue 24 Dec 2019 at 18:39, Remi Pommarel <repk@triplefau.lt> wrote:

> PCIe device probing failures have been seen on AXG platforms and were due
> to unreliable clock signal output. Setting HHI_MIPI_CNTL0[26] bit in
> MIPI's PHY registers solved the problem. This bit appears to control band
> gap reference.
>
> As discussed here [1] one of these shared MIPI/PCIE PHY register bits was
> mistakenly implemented in the clock driver as CLKID_MIPI_ENABLE. This adds
> a PHY driver to control this bit through syscon subsystem instead, as well
> as setting the band gap one in order to get reliable PCIE communication.
>
> While at it adding this PHY make AXG code close to G12A one thus allowing
> to remove some specific platform handling in pci-meson driver.
>
> Please note that CLKID_MIPI_ENABLE removable will be done in a different
> serie.
>
> Changes since v2:
> - Remove shared MIPI/PCIE device driver and use syscon to access register
> in PCIE only driver instead
> - Include devicetree documentation
>
> Changes sinve v1:
> - Move HHI_MIPI_CNTL0 bit control in its own PHY driver
> - Add a PHY driver for PCIE_PHY registers
> - Modify pci-meson.c to make use of both PHYs and remove specific
> handling for AXG and G12A
>
> [1] https://lkml.org/lkml/2019/12/16/119
>
> Remi Pommarel (5):
> phy: amlogic: Add Amlogic AXG PCIE PHY Driver
> PCI: amlogic: Use AXG PCIE PHY
> arm64: dts: meson-axg: Add PCIE PHY node
> dt-bindings: PCI: meson: Update PCIE bindings documentation
> dt-bindings: Add AXG PCIE PHY bindings

Hi Remi,

Usually, you should put the dt documentation first in the series.
This way the properties are documented before being used

>
> .../bindings/pci/amlogic,meson-pcie.txt | 22 +--
> .../bindings/phy/amlogic,meson-axg-pcie.yaml | 51 +++++
> arch/arm64/boot/dts/amlogic/meson-axg.dtsi | 9 +
> drivers/pci/controller/dwc/pci-meson.c | 116 ++---------
> drivers/phy/amlogic/Kconfig | 11 ++
> drivers/phy/amlogic/Makefile | 1 +
> drivers/phy/amlogic/phy-meson-axg-pcie.c | 185 ++++++++++++++++++
> 7 files changed, 287 insertions(+), 108 deletions(-)
> create mode 100644 Documentation/devicetree/bindings/phy/amlogic,meson-axg-pcie.yaml
> create mode 100644 drivers/phy/amlogic/phy-meson-axg-pcie.c

\
 
 \ /
  Last update: 2019-12-26 10:58    [W:0.048 / U:0.184 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site