lkml.org 
[lkml]   [2019]   [Dec]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH V3 1/2] dt-bindings/irq: add binding for NXP INTMUX interrupt multiplexer
From
Date


On 20/12/19 1:07 PM, Joakim Zhang wrote:
> This patch adds the DT bindings for the NXP INTMUX interrupt multiplexer
> for i.MX8 family SoCs.
>
> Signed-off-by: Joakim Zhang <qiangqing.zhang@nxp.com>
> ---
> .../interrupt-controller/fsl,intmux.txt | 36 +++++++++++++++++++
> 1 file changed, 36 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/interrupt-controller/fsl,intmux.txt
>
> diff --git a/Documentation/devicetree/bindings/interrupt-controller/fsl,intmux.txt b/Documentation/devicetree/bindings/interrupt-controller/fsl,intmux.txt
> new file mode 100644
> index 000000000000..3ebe9cac5f20
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/interrupt-controller/fsl,intmux.txt
> @@ -0,0 +1,36 @@
> +Freescale INTMUX interrupt multiplexer
> +
> +Required properties:
> +
> +- compatible: Should be:
> + - "fsl,imx-intmux"
> +- reg: Physical base address and size of registers.
> +- interrupts: Should contain the parent interrupt lines (up to 8) used to
> + multiplex the input interrupts.
> +- clocks: Should contain one clock for entry in clock-names.
> +- clock-names:
> + - "ipg": main logic clock
> +- interrupt-controller: Identifies the node as an interrupt controller.
> +- #interrupt-cells: Specifies the number of cells needed to encode an
> + interrupt source. The value must be 2.
> + - the 1st cell: hardware interrupt number> + - the 2nd cell: channel index, value must smaller than channels used

As per the xlate function, 1st cell is channel index and 2nd cell is hw
interrupt number no?

Thanks and regards,
Lokesh

> +
> +Optional properties:
> +
> +- fsl,intmux_chans: The number of channels used for interrupt source. The
> + Maximum value is 8. If this property is not set in DT then driver uses
> + 1 channel by default.
> +
> +Example:
> +
> + intmux@37400000 {
> + compatible = "fsl,imx-intmux";
> + reg = <0x37400000 0x1000>;
> + interrupts = <GIC_SPI 16 IRQ_TYPE_LEVEL_HIGH>;
> + clocks = <&clk IMX8QM_CM40_IPG_CLK>;
> + clock-names = "ipg";
> + interrupt-controller;
> + #interrupt-cells = <1>;
> + };
> +
>

\
 
 \ /
  Last update: 2019-12-20 12:42    [W:0.066 / U:4.848 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site