lkml.org 
[lkml]   [2019]   [Dec]   [20]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 1/5] phy: qcom-qmp: Increase PHY ready timeout
Date
From: Bjorn Andersson <bjorn.andersson@linaro.org>

It's typical for the QHP PHY to take slightly above 1ms to initialize,
so increase the timeout of the PHY ready check to 10ms - as already done
in the downstream PCIe driver.

Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Tested-by: Evan Green <evgreen@chromium.org>
Tested-by: Vinod Koul <vkoul@kernel.org>
Signed-off-by: Vinod Koul <vkoul@kernel.org>
---
drivers/phy/qualcomm/phy-qcom-qmp.c | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c
index 091e20303a14..66f91726b8b2 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp.c
@@ -66,7 +66,7 @@
/* QPHY_V3_PCS_MISC_CLAMP_ENABLE register bits */
#define CLAMP_EN BIT(0) /* enables i/o clamp_n */

-#define PHY_INIT_COMPLETE_TIMEOUT 1000
+#define PHY_INIT_COMPLETE_TIMEOUT 10000
#define POWER_DOWN_DELAY_US_MIN 10
#define POWER_DOWN_DELAY_US_MAX 11

--
2.23.0
\
 
 \ /
  Last update: 2019-12-20 11:18    [W:0.057 / U:6.944 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site