lkml.org 
[lkml]   [2019]   [Dec]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v1] Bluetooth: hci_qca: Add poweroff support during hci down for QCA Rome
Date
This patch enables power off support for hci down and power on support
for hci up. As QCA Rome power sources are ignited by bt_en GPIO, we will
pull it down during hci down, i.e. an complete power off of QCA Rome.
So while hci up, will pull up the bt_en GPIO again to power on the chip,
requests BT chip version and download the firmware.

Signed-off-by: Rocky Liao <rjliao@codeaurora.org>
---
drivers/bluetooth/hci_qca.c | 34 ++++++++++++++++++++++++++++++----
1 file changed, 30 insertions(+), 4 deletions(-)

diff --git a/drivers/bluetooth/hci_qca.c b/drivers/bluetooth/hci_qca.c
index b602ed01505b..1cb706acdef6 100644
--- a/drivers/bluetooth/hci_qca.c
+++ b/drivers/bluetooth/hci_qca.c
@@ -1257,6 +1257,7 @@ static int qca_setup(struct hci_uart *hu)
{
struct hci_dev *hdev = hu->hdev;
struct qca_data *qca = hu->priv;
+ struct qca_serdev *qcadev;
unsigned int speed, qca_baudrate = QCA_BAUDRATE_115200;
enum qca_btsoc_type soc_type = qca_soc_type(hu);
const char *firmware_name = qca_get_firmware_name(hu);
@@ -1293,6 +1294,17 @@ static int qca_setup(struct hci_uart *hu)
return ret;
} else {
bt_dev_info(hdev, "ROME setup");
+ if (hu->serdev) {
+ /* Enable NON_PERSISTENT_SETUP QUIRK to ensure to
+ * execute setup for every hci up.
+ */
+ set_bit(HCI_QUIRK_NON_PERSISTENT_SETUP, &hdev->quirks);
+ qcadev = serdev_device_get_drvdata(hu->serdev);
+ hu->hdev->shutdown = qca_power_off;
+ gpiod_set_value_cansleep(qcadev->bt_en, 1);
+ /* Controller needs time to bootup. */
+ msleep(150);
+ }
qca_set_speed(hu, QCA_INIT_SPEED);
}

@@ -1413,13 +1425,27 @@ static void qca_power_shutdown(struct hci_uart *hu)
static int qca_power_off(struct hci_dev *hdev)
{
struct hci_uart *hu = hci_get_drvdata(hdev);
+ struct qca_serdev *qcadev;
+ enum qca_btsoc_type soc_type = qca_soc_type(hu);

- /* Perform pre shutdown command */
- qca_send_pre_shutdown_cmd(hdev);
+ if (qca_is_wcn399x(soc_type)) {
+ /* Perform pre shutdown command */
+ qca_send_pre_shutdown_cmd(hdev);

- usleep_range(8000, 10000);
+ usleep_range(8000, 10000);
+
+ qca_power_shutdown(hu);
+ } else {
+ if (hu->serdev) {
+
+ qcadev = serdev_device_get_drvdata(hu->serdev);
+
+ gpiod_set_value_cansleep(qcadev->bt_en, 0);
+
+ usleep_range(8000, 10000);
+ }
+ }

- qca_power_shutdown(hu);
return 0;
}

--
The Qualcomm Innovation Center, Inc. is a member of the Code Aurora Forum, a Linux Foundation Collaborative Project
\
 
 \ /
  Last update: 2019-12-19 05:04    [W:0.029 / U:0.032 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site