lkml.org 
[lkml]   [2019]   [Dec]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 2/4] ARM: dts: qcom: Correct USB3503 GPIOs polarity
On Wed 11 Dec 06:52 PST 2019, Marek Szyprowski wrote:

> Current USB3503 driver ignores GPIO polarity and always operates as if the
> GPIO lines were flagged as ACTIVE_HIGH. Fix the polarity for the existing
> USB3503 chip applications to match the chip specification and common
> convention for naming the pins. The only pin, which has to be ACTIVE_LOW
> is the reset pin. The remaining are ACTIVE_HIGH. This change allows later
> to fix the USB3503 driver to properly use generic GPIO bindings and read
> polarity from DT.
>
> Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>

Acked-by: Bjorn Andersson <bjorn.andersson@linaro.org>

> ---
> arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts | 2 +-
> 1 file changed, 1 insertion(+), 1 deletion(-)
>
> diff --git a/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts b/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts
> index 26160c324802..942e3a2cac35 100644
> --- a/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts
> +++ b/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts
> @@ -143,7 +143,7 @@
> compatible = "smsc,usb3503a";
> reg = <0x8>;
> connect-gpios = <&gpioext2 1 GPIO_ACTIVE_HIGH>;
> - intn-gpios = <&gpioext2 0 GPIO_ACTIVE_LOW>;
> + intn-gpios = <&gpioext2 0 GPIO_ACTIVE_HIGH>;
> initial-mode = <1>;
> };
> };
> --
> 2.17.1
>

\
 
 \ /
  Last update: 2019-12-18 06:42    [W:0.067 / U:4.672 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site