lkml.org 
[lkml]   [2019]   [Dec]   [14]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v2 2/3] scsi: ufs: Modulize ufs-bsg
On 2019-12-13 02:24, Bjorn Andersson wrote:
> On Thu 12 Dec 08:53 PST 2019, cang@codeaurora.org wrote:
>
>> On 2019-12-12 15:00, Avri Altman wrote:
>> > > On Wed 11 Dec 22:01 PST 2019, cang@codeaurora.org wrote:
>> > > > On 2019-12-12 12:53, Bjorn Andersson wrote:
>> > > > > On Wed 11 Dec 00:49 PST 2019, Can Guo wrote:
> [..]
>> > > > And in real cases, as the UFS is the boot device, UFS driver will always
>> > > > be probed during bootup.
>> > > >
>> > >
>> > > The UFS driver will load and probe because it's mentioned in the
>> > > devicetree, but if either the ufs drivers or any of its dependencies
>> > > (phy, resets, clocks, etc) are built as modules it might very well
>> > > finish probing after lateinitcall.
>> > >
>> > > So in the even that the bsg is =y and any of these drivers are =m,
>> > > or if
>> > > you're having bad luck with your timing, the list will be empty.
>> > >
>> > > As described below, if bsg=m, then there's nothing that will load the
>> > > module and the bsg will not probe...
>> > Right.
>> > bsg=y and ufshcd=m is a bad idea, and should be avoided.
>> >
>>
>> Yeah, I will get it addressed in the next patchset.
>>
>
> If you build this around platform_device_register_data() from ufshcd I
> don't see a reason to add additional restrictions on this combination
> (even though it might not make much sense for people to use this
> combination).
>
> Regards,
> Bjorn

Agree, thanks.

Regards,
Can Guo.

\
 
 \ /
  Last update: 2019-12-14 13:31    [W:0.055 / U:4.156 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site