lkml.org 
[lkml]   [2019]   [Dec]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH 2/3] arm64: dts: rockchip: Enable PD for USB-C-Port on rk3399-roc-pc.
From
Date
Hello Markus,

    I have been working with this as well, came across it on Armbian. I was also trying to eliminate the warning concerning the lack of port with limited success.  I also missed the interrupt pin definition I see.  I will test this later today. 

   I've added Neil Armstrong for information in case any boards on the Amlogic side are similarly configured, I think a few other Rockchip ones at least are missing connector nodes, it appears to be a consistent issue presumably due to driver changes.

-Tony




On Dec 10, 2019, 7:45 AM, at 7:45 AM, Markus Reichl <m.reichl@fivetechno.de> wrote:
>USB-C-Port 0 on rk3399-roc-pc is designed to supply the board.
>To meet the power requirements of up to 45W a power delivery (PD)
>compatible supply is needed. To configure the PD the node of the
>fusb302 needs a connector property with desired PD description.
>
>Signed-off-by: Markus Reichl <m.reichl@fivetechno.de>
>---
>Presently the board in mainline has to be powered from a 12V supply,
>connected to two pins on the expansion header as the standard 5V
>delivered by the unconfigured USB-C plug is not enough for higher
>loads or peripherals on USB or M.2.
>
>With this patch the board requests 15V from the PD and runs fine
>on high loads with NVME SSD, Ethernet, SDIO WLAN and USB peripherals.
>During boot the 12V supply is still needed for some seconds,
>as the fusb302 shuts down or resets the PD shortly when initializing
>(BUG?).
>
>The board's 12V line is running presently on 5V, the default output
>voltage of the MP8859 on I2C-7, for wich no mainline kernel driver
>exists yet.
>---
> arch/arm64/boot/dts/rockchip/rk3399-roc-pc.dtsi | 16 ++++++++++++++--
> 1 file changed, 14 insertions(+), 2 deletions(-)
>
>diff --git a/arch/arm64/boot/dts/rockchip/rk3399-roc-pc.dtsi
>b/arch/arm64/boot/dts/rockchip/rk3399-roc-pc.dtsi
>index 8e01b04144b7..90783b2b1d1f 100644
>--- a/arch/arm64/boot/dts/rockchip/rk3399-roc-pc.dtsi
>+++ b/arch/arm64/boot/dts/rockchip/rk3399-roc-pc.dtsi
>@@ -6,6 +6,7 @@
> /dts-v1/;
> #include <dt-bindings/input/linux-event-codes.h>
> #include <dt-bindings/pwm/pwm.h>
>+#include <dt-bindings/usb/pd.h>
> #include "rk3399.dtsi"
> #include "rk3399-opp.dtsi"
>
>@@ -540,11 +541,22 @@ fusb0: usb-typec@22 {
> compatible = "fcs,fusb302";
> reg = <0x22>;
> interrupt-parent = <&gpio1>;
>- interrupts = <2 IRQ_TYPE_LEVEL_LOW>;
>+ interrupts = <RK_PA2 IRQ_TYPE_LEVEL_LOW>;
> pinctrl-names = "default";
> pinctrl-0 = <&fusb0_int>;
> vbus-supply = <&vcc_vbus_typec0>;
>- status = "okay";
>+
>+ usb_con: connector {
>+ compatible = "usb-c-connector";
>+ label = "USB-C-0";
>+ power-role = "dual";
>+ try-power-role = "sink";
>+ source-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)>;
>+ sink-pdos = <PDO_FIXED(5000, 3000, PDO_FIXED_USB_COMM)
>+ PDO_VAR(5000, 15000, 3000)
>+ PDO_PPS_APDO(5000, 15000, 3000)>;
>+ op-sink-microwatt = <45000000>;
>+ };
> };
> };
>
>--
>2.24.0
>
>
>_______________________________________________
>Linux-rockchip mailing list
>Linux-rockchip@lists.infradead.org
>http://lists.infradead.org/mailman/listinfo/linux-rockchip

\
 
 \ /
  Last update: 2019-12-12 17:08    [W:0.039 / U:6.272 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site