lkml.org 
[lkml]   [2019]   [Dec]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v2 2/4] ARM: dts: qcom: Correct USB3503 GPIOs polarity
Date
Current USB3503 driver ignores GPIO polarity and always operates as if the
GPIO lines were flagged as ACTIVE_HIGH. Fix the polarity for the existing
USB3503 chip applications to match the chip specification and common
convention for naming the pins. The only pin, which has to be ACTIVE_LOW
is the reset pin. The remaining are ACTIVE_HIGH. This change allows later
to fix the USB3503 driver to properly use generic GPIO bindings and read
polarity from DT.

Signed-off-by: Marek Szyprowski <m.szyprowski@samsung.com>
---
arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts b/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts
index 26160c324802..942e3a2cac35 100644
--- a/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts
+++ b/arch/arm/boot/dts/qcom-mdm9615-wp8548-mangoh-green.dts
@@ -143,7 +143,7 @@
compatible = "smsc,usb3503a";
reg = <0x8>;
connect-gpios = <&gpioext2 1 GPIO_ACTIVE_HIGH>;
- intn-gpios = <&gpioext2 0 GPIO_ACTIVE_LOW>;
+ intn-gpios = <&gpioext2 0 GPIO_ACTIVE_HIGH>;
initial-mode = <1>;
};
};
--
2.17.1
\
 
 \ /
  Last update: 2019-12-11 15:47    [W:0.043 / U:15.632 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site