lkml.org 
[lkml]   [2019]   [Dec]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[Patch v6 6/7] thermal/cpu-cooling: Update thermal pressure in case of a maximum frequency capping
Date
Thermal governors can request for a cpu's maximum supported frequency to
be capped in case of an overheat event. This in turn means that the
maximum capacity available for tasks to run on the particular cpu is
reduced. Delta between the original maximum capacity and capped maximum
capacity is known as thermal pressure. Enable cpufreq cooling device to
update the thermal pressure in event of a capped maximum frequency.

Signed-off-by: Thara Gopinath <thara.gopinath@linaro.org>
---

v4->v5:
- fixed issues in update_sched_max_capacity comment header.
- Updated update_sched_max_capacity to calculate maximum available
capacity.
v5->v6:
- Removed update_sched_max_capacity. Instead call directly into
arch_set_thermal_pressure to update thermal pressure.

drivers/thermal/cpu_cooling.c | 19 +++++++++++++++++--
1 file changed, 17 insertions(+), 2 deletions(-)

diff --git a/drivers/thermal/cpu_cooling.c b/drivers/thermal/cpu_cooling.c
index 52569b2..c97c13e 100644
--- a/drivers/thermal/cpu_cooling.c
+++ b/drivers/thermal/cpu_cooling.c
@@ -430,6 +430,10 @@ static int cpufreq_set_cur_state(struct thermal_cooling_device *cdev,
unsigned long state)
{
struct cpufreq_cooling_device *cpufreq_cdev = cdev->devdata;
+ struct cpumask *cpus;
+ unsigned int frequency;
+ unsigned long capacity;
+ int ret;

/* Request state should be less than max_level */
if (WARN_ON(state > cpufreq_cdev->max_level))
@@ -441,8 +445,19 @@ static int cpufreq_set_cur_state(struct thermal_cooling_device *cdev,

cpufreq_cdev->cpufreq_state = state;

- return freq_qos_update_request(&cpufreq_cdev->qos_req,
- get_state_freq(cpufreq_cdev, state));
+ frequency = get_state_freq(cpufreq_cdev, state);
+
+ ret = freq_qos_update_request(&cpufreq_cdev->qos_req, frequency);
+
+ if (ret > 0) {
+ cpus = cpufreq_cdev->policy->cpus;
+ capacity = frequency *
+ arch_scale_cpu_capacity(cpumask_first(cpus));
+ capacity /= cpufreq_cdev->policy->cpuinfo.max_freq;
+ arch_set_thermal_pressure(cpus, capacity);
+ }
+
+ return ret;
}

/* Bind cpufreq callbacks to thermal cooling device ops */
--
2.1.4
\
 
 \ /
  Last update: 2019-12-12 05:12    [W:0.121 / U:3.796 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site