lkml.org 
[lkml]   [2019]   [Dec]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v2 1/9] input: elants: document some registers and values
From
Date
11.12.2019 19:03, Michał Mirosław пишет:
> Add information found in downstream kernels, to make the code less
> magic.
>
> Signed-off-by: Michał Mirosław <mirq-linux@rere.qmqm.pl>
> ---
> drivers/input/touchscreen/elants_i2c.c | 29 +++++++++++++++++++++-----
> 1 file changed, 24 insertions(+), 5 deletions(-)
>
> diff --git a/drivers/input/touchscreen/elants_i2c.c b/drivers/input/touchscreen/elants_i2c.c
> index d4ad24ea54c8..887888c53996 100644
> --- a/drivers/input/touchscreen/elants_i2c.c
> +++ b/drivers/input/touchscreen/elants_i2c.c
> @@ -77,7 +77,11 @@
>
> #define HEADER_REPORT_10_FINGER 0x62
>
> -/* Header (4 bytes) plus 3 fill 10-finger packets */
> +/* Power state */
> +#define PWR_STATE_DEEP_SLEEP 0
> +#define PWR_STATE_NORMAL 1
> +
> +/* Header (4 bytes) plus 3 full 10-finger packets */
> #define MAX_PACKET_SIZE 169
>
> #define BOOT_TIME_DELAY_MS 50
> @@ -87,10 +91,21 @@
> #define E_ELAN_INFO_BC_VER 0x10
> #define E_ELAN_INFO_TEST_VER 0xE0
> #define E_ELAN_INFO_FW_ID 0xF0
> +#define E_POWER_MODE 0x40
> +#define E_POWER_STATE 0x50
> +#define E_INFO_X_RES 0x60
> +#define E_INFO_Y_RES 0x63
> #define E_INFO_OSR 0xD6
> #define E_INFO_PHY_SCAN 0xD7
> #define E_INFO_PHY_DRIVER 0xD8

> +/* FW write command, 0x54 0x?? 0x0, 0x01 */
> +#define E_POWER_MODE_BATTERY 0x40
> +#define E_POWER_MODE_AC 0x41

These commands are not utilized yet, but perhaps it's okay to add the
definitions if you're going to add support for power source switching.

> +#define E_POWER_MODE_USB 0x42
> +#define E_POWER_STATE_SLEEP 0x50
> +#define E_POWER_STATE_RESUME 0x58
> +
> #define MAX_RETRIES 3
> #define MAX_FW_UPDATE_RETRIES 30
>
> @@ -231,8 +246,8 @@ static int elants_i2c_calibrate(struct elants_data *ts)
> {
> struct i2c_client *client = ts->client;
> int ret, error;
> - static const u8 w_flashkey[] = { 0x54, 0xC0, 0xE1, 0x5A };
> - static const u8 rek[] = { 0x54, 0x29, 0x00, 0x01 };
> + static const u8 w_flashkey[] = { CMD_HEADER_WRITE, 0xC0, 0xE1, 0x5A };
> + static const u8 rek[] = { CMD_HEADER_WRITE, 0x29, 0x00, 0x01 };
> static const u8 rek_resp[] = { CMD_HEADER_REK, 0x66, 0x66, 0x66 };
>
> disable_irq(client->irq);
> @@ -1295,7 +1310,9 @@ static int __maybe_unused elants_i2c_suspend(struct device *dev)
> {
> struct i2c_client *client = to_i2c_client(dev);
> struct elants_data *ts = i2c_get_clientdata(client);
> - const u8 set_sleep_cmd[] = { 0x54, 0x50, 0x00, 0x01 };
> + const u8 set_sleep_cmd[] = {
> + CMD_HEADER_WRITE, E_POWER_STATE_SLEEP, 0x00, 0x01
> + };
> int retry_cnt;
> int error;
>
> @@ -1332,7 +1349,9 @@ static int __maybe_unused elants_i2c_resume(struct device *dev)
> {
> struct i2c_client *client = to_i2c_client(dev);
> struct elants_data *ts = i2c_get_clientdata(client);
> - const u8 set_active_cmd[] = { 0x54, 0x58, 0x00, 0x01 };
> + const u8 set_active_cmd[] = {
> + CMD_HEADER_WRITE, E_POWER_STATE_RESUME, 0x00, 0x01
> + };
> int retry_cnt;
> int error;
>
>

Reviewed-by: Dmitry Osipenko <digetx@gmail.com>
Tested-by: Dmitry Osipenko <digetx@gmail.com>

\
 
 \ /
  Last update: 2019-12-12 01:34    [W:0.090 / U:0.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site