lkml.org 
[lkml]   [2019]   [Dec]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 4.19 057/243] ARM: dts: imx6: RDU2: fix eGalax touchscreen node
Date
From: Lucas Stach <l.stach@pengutronix.de>

[ Upstream commit 749a5068f2e2453a38777b1d5fc322d503cabf1d ]

Use the correct compatible for the new protocol used by the firmware
on the touch controller, the GPIO wakeup isn't used in that case.
Also eGalax touch needs axis swapping, just as with the RMI4 touch.

Signed-off-by: Lucas Stach <l.stach@pengutronix.de>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
index 7fff3717cf7c0..315d0e7615f33 100644
--- a/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
+++ b/arch/arm/boot/dts/imx6qdl-zii-rdu2.dtsi
@@ -609,13 +609,14 @@
};

touchscreen@2a {
- compatible = "eeti,egalax_ts";
+ compatible = "eeti,exc3000";
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_ts>;
reg = <0x2a>;
interrupt-parent = <&gpio1>;
interrupts = <8 IRQ_TYPE_LEVEL_LOW>;
- wakeup-gpios = <&gpio1 8 GPIO_ACTIVE_LOW>;
+ touchscreen-inverted-x;
+ touchscreen-swapped-x-y;
status = "disabled";
};

--
2.20.1


\
 
 \ /
  Last update: 2019-12-11 16:55    [W:0.660 / U:3.100 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site