lkml.org 
[lkml]   [2019]   [Dec]   [10]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH 1/3] ARM: dts: imx6ul-14x14-evk: Add sensors' GPIO regulator
Date
On 24.10.2019 11:51, Anson Huang wrote:
> On i.MX6UL 14x14 EVK board, sensors' power are controlled
> by GPIO5_IO02, add GPIO regulator for sensors to manage
> their power.
>
> Signed-off-by: Anson Huang <Anson.Huang@nxp.com>

For me this breaks network boot on imx6ul evk, relevant log snippet is this:

fec 20b4000.ethernet eth0: Unable to connect to phy
IP-Config: Failed to open eth0

Looking at schematics (SPF-28616_C2.pdf) I see that SNVS_TAMPER2 pin is
connected to PERI_PWREN which controls VPERI_3V3 which is used across
the board:
* Sensors (VSENSOR_3V3)
* Ethernet (VENET_3V3)
* Bluetooth
* CAN
* Arduino header
* Camera

Maybe there are board revision differences? As far as I can tell this
regulator is not specific to sensors so it should be always on.

> ---
> arch/arm/boot/dts/imx6ul-14x14-evk.dtsi | 16 ++++++++++++++++
> 1 file changed, 16 insertions(+)
>
> diff --git a/arch/arm/boot/dts/imx6ul-14x14-evk.dtsi b/arch/arm/boot/dts/imx6ul-14x14-evk.dtsi
> index c2a9dd5..4074570 100644
> --- a/arch/arm/boot/dts/imx6ul-14x14-evk.dtsi
> +++ b/arch/arm/boot/dts/imx6ul-14x14-evk.dtsi
> @@ -30,6 +30,16 @@
> enable-active-high;
> };
>
> + reg_sensors: regulator-sensors {
> + compatible = "regulator-fixed";
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_sensors_reg>;
> + regulator-name = "sensors-supply";
> + regulator-min-microvolt = <3300000>;
> + regulator-max-microvolt = <3300000>;
> + gpio = <&gpio5 2 GPIO_ACTIVE_LOW>;
> + };
> +
> reg_can_3v3: regulator-can-3v3 {
> compatible = "regulator-fixed";
> regulator-name = "can-3v3";
> @@ -448,6 +458,12 @@
> >;
> };
>
> + pinctrl_sensors_reg: sensorsreggrp {
> + fsl,pins = <
> + MX6UL_PAD_SNVS_TAMPER2__GPIO5_IO02 0x1b0b0
> + >;
> + };
> +
> pinctrl_pwm1: pwm1grp {
> fsl,pins = <
> MX6UL_PAD_GPIO1_IO08__PWM1_OUT 0x110b0
>


\
 
 \ /
  Last update: 2019-12-10 22:36    [W:0.053 / U:0.272 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site