[lkml]   [2019]   [Oct]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH 3/3] gpio: max77620: Fix interrupt handling
On Wed, Oct 2, 2019 at 2:28 PM Thierry Reding <> wrote:

> From: Timo Alho <>
> The interrupt-related register fields on the MAX77620 GPIO controller
> share registers with GPIO related fields. If the IRQ chip is implemented
> with regmap-irq, this causes the IRQ controller code to overwrite fields
> previously configured by the GPIO controller code.
> Two examples where this causes problems are the NVIDIA Jetson TX1 and
> Jetson TX2 boards, where some of the GPIOs are used to enable vital
> power regulators. The MAX77620 GPIO controller also provides the USB OTG
> ID pin. If configured as an interrupt, this causes some of the
> regulators to be powered off.
> Signed-off-by: Timo Alho <>
> Signed-off-by: Thierry Reding <>

Patch applied.

I am looking for ways to pass also nested irqchips along when registering
the gpio_chip but I guess I need to clean up all the chained chips
first (getting there...)

Linus Walleij

 \ /
  Last update: 2019-10-05 00:04    [W:0.130 / U:0.108 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site