[lkml]   [2019]   [Oct]   [1]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Patch in this message
Subject[PATCH v10 07/16] dt: bindings: lp55xx: Be consistent in the document with LED acronym
Update the document to be consistent in case when using "LED".
This acronym should be capital throughout the document.

Signed-off-by: Dan Murphy <>
Documentation/devicetree/bindings/leds/leds-lp55xx.txt | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/leds/leds-lp55xx.txt b/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
index 1b66a413fb9d..bfe2805c5534 100644
--- a/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
+++ b/Documentation/devicetree/bindings/leds/leds-lp55xx.txt
@@ -1,4 +1,4 @@
-Binding for TI/National Semiconductor LP55xx Led Drivers
+Binding for TI/National Semiconductor LP55xx LED Drivers

Required properties:
- compatible: one of
@@ -12,8 +12,8 @@ Required properties:
- clock-mode: Input clock mode, (0: automode, 1: internal, 2: external)

Each child has own specific current settings
-- led-cur: Current setting at each led channel (mA x10, 0 if led is not connected)
-- max-cur: Maximun current at each led channel.
+- led-cur: Current setting at each LED channel (mA x10, 0 if LED is not connected)
+- max-cur: Maximun current at each LED channel.

Optional properties:
- enable-gpio: GPIO attached to the chip's enable pin
 \ /
  Last update: 2019-10-01 16:56    [W:0.272 / U:3.164 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site