lkml.org 
[lkml]   [2019]   [Jan]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 5/7] dt-bindings: add bindings for SAM9X60
Date
From: Claudiu Beznea <claudiu.beznea@microchip.com>

Add device tree binding for SAM9X60 pin controller.

Signed-off-by: Claudiu Beznea <claudiu.beznea@microchip.com>
---
Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt
index 40e33dfc36fd..c2d51ed86d47 100644
--- a/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt
+++ b/Documentation/devicetree/bindings/pinctrl/atmel,at91-pinctrl.txt
@@ -19,7 +19,7 @@ such as pull-up, multi drive, etc.

Required properties for iomux controller:
- compatible: "atmel,at91rm9200-pinctrl" or "atmel,at91sam9x5-pinctrl"
- or "atmel,sama5d3-pinctrl"
+ or "atmel,sama5d3-pinctrl" or "microchip,sam9x60-pictrl"
- atmel,mux-mask: array of mask (periph per bank) to describe if a pin can be
configured in this periph mode. All the periph and bank need to be describe.

@@ -117,7 +117,8 @@ Some requirements for using atmel,at91rm9200-pinctrl binding:
4. The gpio controller must be describe in the pinctrl simple-bus.

For each bank the required properties are:
-- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio"
+- compatible: "atmel,at91sam9x5-gpio" or "atmel,at91rm9200-gpio" or
+ "microchip,sam9x60-gpio"
- reg: physical base address and length of the controller's registers
- interrupts: interrupt outputs from the controller
- interrupt-controller: marks the device node as an interrupt controller
--
2.7.4
\
 
 \ /
  Last update: 2019-01-31 13:30    [W:0.087 / U:24.264 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site