lkml.org 
[lkml]   [2019]   [Jan]   [30]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH 05/10] arm64: dts: allwinner: h5: orange-pi-zero-plus: Add CPU regulator supply
Date
The OrangePi Zero Plus uses a fixed regulator to supply the CPU cores.
The feedback resistor network can be changed by toggling a GPIO line.
This is effectively a GPIO controlled regulator that can change between
roughly 1.1V and 1.3V. The actual voltage is slightly higher. The values
used in the device tree description are based on calculations using the
resistor values from the schematics.

Cc: Hauke Mehrtens <hauke@hauke-m.de>
Signed-off-by: Chen-Yu Tsai <wens@csie.org>

---

This patch is based on the schematics and has not been tested on an
actual board.
---
.../sun50i-h5-orangepi-zero-plus.dts | 20 +++++++++++++++++++
1 file changed, 20 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus.dts b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus.dts
index 1238de25a969..3493eea7cf29 100644
--- a/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus.dts
+++ b/arch/arm64/boot/dts/allwinner/sun50i-h5-orangepi-zero-plus.dts
@@ -57,6 +57,26 @@
enable-active-high;
gpio = <&pio 3 6 GPIO_ACTIVE_HIGH>; /* PD6 */
};
+
+ reg_vdd_cpux: vdd-cpux {
+ compatible = "regulator-gpio";
+ regulator-name = "vdd-cpux";
+ regulator-type = "voltage";
+ regulator-boot-on;
+ regulator-always-on;
+ regulator-min-microvolt = <1108475>;
+ regulator-max-microvolt = <1307810>;
+ regulator-ramp-delay = <50>; /* 4ms */
+ enable-gpios = <&r_pio 0 8 GPIO_ACTIVE_HIGH>; /* PL8 */
+ gpios = <&r_pio 0 1 GPIO_ACTIVE_HIGH>; /* PL6 */
+ gpios-states = <0x1>;
+ states = <1108475 0x0
+ 1307810 0x1>;
+ };
+};
+
+&cpu0 {
+ cpu-supply = <&reg_vdd_cpux>;
};

&ehci0 {
--
2.20.1
\
 
 \ /
  Last update: 2019-01-30 09:43    [W:0.131 / U:14.416 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site