lkml.org 
[lkml]   [2019]   [Jan]   [22]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH V4 1/3] dt-bindings: mmc: tegra: Add pinctrl for SDMMC drive strengths
On Thu, 10 Jan 2019 at 23:46, Sowjanya Komatineni
<skomatineni@nvidia.com> wrote:
>
> Add pinctrls for 3V3 and 1V8 pad drive strength configuration for
> Tegra210 sdmmc.
>
> Tegra210 sdmmc has pad configuration registers in pinmux register
> domain and handled thru pinctrl to pinmux device node.
>
> Tegra186 and Tegra194 has pad configuration register with in the
> SDMMC register domain itself and are handles thru drive strength
> properties in sdmmc device node.
>
> Signed-off-by: Sowjanya Komatineni <skomatineni@nvidia.com>

Applied for next, thanks!

Kind regards
Uffe


> ---
> Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt | 6 +++++-
> 1 file changed, 5 insertions(+), 1 deletion(-)
>
> diff --git a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
> index 32b4b4e41923..2cecdc71d94c 100644
> --- a/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
> +++ b/Documentation/devicetree/bindings/mmc/nvidia,tegra20-sdhci.txt
> @@ -39,12 +39,16 @@ sdhci@c8000200 {
> bus-width = <8>;
> };
>
> -Optional properties for Tegra210 and Tegra186:
> +Optional properties for Tegra210, Tegra186 and Tegra194:
> - pinctrl-names, pinctrl-0, pinctrl-1 : Specify pad voltage
> configurations. Valid pinctrl-names are "sdmmc-3v3" and "sdmmc-1v8"
> for controllers supporting multiple voltage levels. The order of names
> should correspond to the pin configuration states in pinctrl-0 and
> pinctrl-1.
> +- pinctrl-names : "sdmmc-3v3-drv" and "sdmmc-1v8-drv" are applicable for
> + Tegra210 where pad config registers are in the pinmux register domain
> + for pull-up-strength and pull-down-strength values configuration when
> + using pads at 3V3 and 1V8 levels.
> - nvidia,only-1-8-v : The presence of this property indicates that the
> controller operates at a 1.8 V fixed I/O voltage.
> - nvidia,pad-autocal-pull-up-offset-3v3,
> --
> 2.7.4
>

\
 
 \ /
  Last update: 2019-01-22 08:49    [W:0.105 / U:35.692 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site