lkml.org 
[lkml]   [2019]   [Jan]   [17]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] Documentation: gpio: driver: fix wire name for I2C
Date
Typo: the data line is called "SDA" not "SCA".

Signed-off-by: Wolfram Sang <wsa+renesas@sang-engineering.com>
---
Documentation/driver-api/gpio/driver.rst | 2 +-
1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/Documentation/driver-api/gpio/driver.rst b/Documentation/driver-api/gpio/driver.rst
index a92d8837b62b..3043167fc557 100644
--- a/Documentation/driver-api/gpio/driver.rst
+++ b/Documentation/driver-api/gpio/driver.rst
@@ -135,7 +135,7 @@ This configuration is normally used as a way to achieve one of two things:
- inverse wire-OR on an I/O line, for example a GPIO line, making it possible
for any driving stage on the line to drive it low even if any other output
to the same line is simultaneously driving it high. A special case of this
- is driving the SCL and SCA lines of an I2C bus, which is by definition a
+ is driving the SCL and SDA lines of an I2C bus, which is by definition a
wire-OR bus.

Both usecases require that the line be equipped with a pull-up resistor. This
--
2.11.0
\
 
 \ /
  Last update: 2019-01-17 11:14    [W:0.040 / U:7.840 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site