lkml.org 
[lkml]   [2019]   [Jan]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: Regression: spi: core: avoid waking pump thread from spi_sync instead run teardown delayed
From
Date

On 15/01/2019 15:10, Mark Brown wrote:
> On Tue, Jan 15, 2019 at 02:26:02PM +0000, Jon Hunter wrote:
>
>> It seems that __spi_pump_messages() is getting called several times
>> during boot when registering the spi-flash, then after the spi-flash has
>> been registered, about a 1 sec later spi_pump_idle_teardown() is called
>> (as expected), but exits because 'ctlr->running' is true. However,
>> spi_pump_idle_teardown() is never called again and when we suspend we
>> are stuck in the busy/running state. In this case should something be
>> scheduling spi_pump_idle_teardown() again? Although even if it does I
>> don't see where the busy flag would be cleared in this path?
>
> Right, I think with the current code we just shouldn't be checking for
> busy in teardown, since there's now a fairly big delay between idle and
> actually turning the hardware off the name is just super misleading and
> the logic confused. I don't have time to test right now but does
> something like the below which changes it to a flag for the hardware
> being powered up work:

I tried your change but the same problem still persists.

Cheers
Jon

--
nvpublic

\
 
 \ /
  Last update: 2019-01-15 17:10    [W:0.094 / U:70.308 seconds]
©2003-2018 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site