[lkml]   [2019]   [Jan]   [15]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [RFC PATCH v4 12/13] irqchip: ti-sci-inta: Add support for Interrupt Aggregator driver
On 14:38-20190115, Tero Kristo wrote:
> The mentioned failure only happens with a specific .config. Not sure what is
> the actual Kconfig that masks the failure though, but anyway it looks like
> interrupt.h gets included via some indirect path with arm64 defconfig making
> it pass.

I am able to reproduce the build fail as well:
.config: -> Notice that all v8 arch other than K3 is disabled, expert
mode is enabled and few ancillary "optimization" of config
Here is what I did:
git checkout next-20190115
wget -O inta.mbox
git am inta.mbox
I put the above .config as my .config
make oldconfig
make drivers/irqchip/irq-ti-sci-inta.o

I got the exact failure as well..

I agree with peter than this should be fixed. randconfig would have
caught this anyways.. I did'nt bother looking further in the config to
figure out why the side effect, but glad it got caught early enough.

Thanks Peter.

Lokesh, I know you are out this week, will appreciate if you could post
a v5 once you are back?

Nishanth Menon

 \ /
  Last update: 2019-01-15 15:06    [W:0.086 / U:0.040 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site