[lkml]   [2019]   [Jan]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v3] arm64: dts: meson: Fix mmc cd-gpios polarity
Martin Blumenstingl <> writes:

> Hi,
> some nit-picks as well as my Tested-by (in case it's not too late) below.
> thank you for taking care of this!
> On Thu, Jan 10, 2019 at 4:40 PM Loys Ollivier <> wrote:
>> Commit 89a5e15bcba8 ("gpio/mmc/of: Respect polarity in the device tree")
>> changed the behavior of "cd-inverted" to follow the device tree bindings
>> specification.
>> Lines specifying "cd-inverted" are now "active high".
> this depends on the polarity from the cd-gpios property. above commit
> caused cd-inverted to be applied twice (effectively making it a
> no-op). thus "cd-inverted" only means "active high" if cd-gpios also
> sets GPIO_ACTIVE_HIGH. if the polarity in cd-gpios is GPIO_ACTIVE_LOW
> together with "cd-inverted" then the GPIO will be treated as active
> low.
>> Fix the SD card for meson by setting the cd-gpios as "active low" according
>> to the boards specifications.
> not only switching to GPIO_ACTIVE_LOW, also dropping "cd-inverted"
>> Fixes: 89a5e15bcba8 ("gpio/mmc/of: Respect polarity in the device tree")
> in my patches for the 32-bit boards I used the commit which added SD
> card support to the board for the Fixes tag. however, I'm fine with
> this as well (I just wanted to point out that there's a small
> difference in our commits).
>> Signed-off-by: Loys Ollivier <>
> on my Khadas VIM(1), using Kevin's v5.0/fixes branch:
> Tested-by: Martin Blumenstingl <>

I can add this tested-by tag in my v5.0/fixes branch for now, and can
replace it with a follow up if Loys can update the changelog with your



 \ /
  Last update: 2019-01-11 20:57    [W:0.067 / U:2.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site