[lkml]   [2019]   [Jan]   [11]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v3] arm64: dts: meson: Fix mmc cd-gpios polarity

some nit-picks as well as my Tested-by (in case it's not too late) below.
thank you for taking care of this!

On Thu, Jan 10, 2019 at 4:40 PM Loys Ollivier <> wrote:
> Commit 89a5e15bcba8 ("gpio/mmc/of: Respect polarity in the device tree")
> changed the behavior of "cd-inverted" to follow the device tree bindings
> specification.
> Lines specifying "cd-inverted" are now "active high".
this depends on the polarity from the cd-gpios property. above commit
caused cd-inverted to be applied twice (effectively making it a
no-op). thus "cd-inverted" only means "active high" if cd-gpios also
sets GPIO_ACTIVE_HIGH. if the polarity in cd-gpios is GPIO_ACTIVE_LOW
together with "cd-inverted" then the GPIO will be treated as active

> Fix the SD card for meson by setting the cd-gpios as "active low" according
> to the boards specifications.
not only switching to GPIO_ACTIVE_LOW, also dropping "cd-inverted"

> Fixes: 89a5e15bcba8 ("gpio/mmc/of: Respect polarity in the device tree")
in my patches for the 32-bit boards I used the commit which added SD
card support to the board for the Fixes tag. however, I'm fine with
this as well (I just wanted to point out that there's a small
difference in our commits).

> Signed-off-by: Loys Ollivier <>
on my Khadas VIM(1), using Kevin's v5.0/fixes branch:
Tested-by: Martin Blumenstingl <>


 \ /
  Last update: 2019-01-11 20:49    [W:0.084 / U:1.708 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site