lkml.org 
[lkml]   [2018]   [Sep]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
SubjectApplied "spi: dw: support 4-16 bits per word" to the spi tree
Date
The patch

spi: dw: support 4-16 bits per word

has been applied to the spi tree at

https://git.kernel.org/pub/scm/linux/kernel/git/broonie/spi.git

All being well this means that it will be integrated into the linux-next
tree (usually sometime in the next 24 hours) and sent to Linus during
the next merge window (or sooner if it is a bug fix), however if
problems are discovered then the patch may be dropped or reverted.

You may get further e-mails resulting from automated or manual testing
and review of the tree, please engage with people reporting problems and
send followup patches addressing any issues that are reported if needed.

If any updates are required or you are submitting further changes they
should be sent as incremental updates against current git, existing
patches will not be replaced.

Please add any relevant lists and maintainers to the CCs when replying
to this mail.

Thanks,
Mark

From af060b3f72b801962033f75a2fda25fff992796d Mon Sep 17 00:00:00 2001
From: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
Date: Tue, 4 Sep 2018 21:49:44 +0200
Subject: [PATCH] spi: dw: support 4-16 bits per word

The spi-dw driver currently only supports 8 or 16 bits per word.

Since the hardware supports 4-16 bits per word, adapt the driver
to also support this.

Tested on socfpga cyclone5 with a 9-bit SPI display.

Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
Reviewed-by: Andy Shevchenko <andy.shevchenko@gmail.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
---
drivers/spi/spi-dw.c | 15 +++++----------
1 file changed, 5 insertions(+), 10 deletions(-)

diff --git a/drivers/spi/spi-dw.c b/drivers/spi/spi-dw.c
index 1736612ee86b..3e205ab60cd4 100644
--- a/drivers/spi/spi-dw.c
+++ b/drivers/spi/spi-dw.c
@@ -308,15 +308,10 @@ static int dw_spi_transfer_one(struct spi_controller *master,
dws->current_freq = transfer->speed_hz;
spi_set_clk(dws, chip->clk_div);
}
- if (transfer->bits_per_word == 8) {
- dws->n_bytes = 1;
- dws->dma_width = 1;
- } else if (transfer->bits_per_word == 16) {
- dws->n_bytes = 2;
- dws->dma_width = 2;
- } else {
- return -EINVAL;
- }
+
+ dws->n_bytes = DIV_ROUND_UP(transfer->bits_per_word, BITS_PER_BYTE);
+ dws->dma_width = DIV_ROUND_UP(transfer->bits_per_word, BITS_PER_BYTE);
+
/* Default SPI mode is SCPOL = 0, SCPH = 0 */
cr0 = (transfer->bits_per_word - 1)
| (chip->type << SPI_FRF_OFFSET)
@@ -496,7 +491,7 @@ int dw_spi_add_host(struct device *dev, struct dw_spi *dws)
}

master->mode_bits = SPI_CPOL | SPI_CPHA | SPI_LOOP;
- master->bits_per_word_mask = SPI_BPW_MASK(8) | SPI_BPW_MASK(16);
+ master->bits_per_word_mask = SPI_BPW_RANGE_MASK(4, 16);
master->bus_num = dws->bus_num;
master->num_chipselect = dws->num_cs;
master->setup = dw_spi_setup;
--
2.19.0.rc1
\
 
 \ /
  Last update: 2018-09-06 13:10    [W:0.082 / U:2.812 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site