lkml.org 
[lkml]   [2018]   [Sep]   [3]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectIRQ number question.
Hi, 

I'm writing a kernel driver. It is not going to be widely used, so I'm
not motivated to make things nice enough for inclusion in the standard
kernel.

But lspci shows my device:

03:01.0 Serial bus controller [0c80]: Phoenix Contact GmbH & Co. Device 0002 (rev b7)
Flags: bus master, stepping, medium devsel, latency 32, IRQ 14
I/O ports at e070 [size=16]
Memory at f7d00000 (32-bit, non-prefetchable) [size=256K]

Now when I start my module and prod the device a bit, it will generate
an interrupt. (in this case the monitor program needs to start sending
messages to the card.)

Then the kernel reports:

irq 18: nobody cared (try booting with the "irqpoll" option)

I've been writing device drivers in the past, but in the past
when the lspci listed "IRQ 14" then I'd have to request_irq (14, ...

Has this changed? Or is this hardware "odd"/"bad"/"broken" in that it
initializes the PCI devices wrong? (*)

My driver now works with the interrupts coming in nicely on IRQ18...

I have this card where I'm writing my own driver, and another PCI card
that uses an "included-in-the-kernel" driver, and it too behaves as if
it doesn't get any interrupts.

Roger.

(*) Obviously according to everybody "windows works", so could it be
that modern windows simply activates an irq and polls to see what
driver handles it? Or something like that? Ah! That would be somewhat
similar to what "irqpoll" does on Linux!

--
** R.E.Wolff@BitWizard.nl ** http://www.BitWizard.nl/ ** +31-15-2600998 **
** Delftechpark 26 2628 XH Delft, The Netherlands. KVK: 27239233 **
*-- BitWizard writes Linux device drivers for any device you may have! --*
The plan was simple, like my brother-in-law Phil. But unlike
Phil, this plan just might work.

\
 
 \ /
  Last update: 2018-09-03 19:49    [W:0.060 / U:0.316 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site