[lkml]   [2018]   [Sep]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH V4 3/4] spi: spi-geni-qcom: Add SPI driver support for GENI based QUP

On Tue, Sep 18, 2018 at 11:09 AM Dilip Kota <> wrote:
> From: Girish Mahadevan <>
> This driver supports GENI based SPI Controller in the Qualcomm SOCs. The
> Qualcomm Generic Interface (GENI) is a programmable module supporting a
> wide range of serial interfaces including SPI. This driver supports SPI
> operations using FIFO mode of transfer.
> Signed-off-by: Girish Mahadevan <>
> Signed-off-by: Dilip Kota <>
> ---
> Addressing all the reviewer commets given in Patchset1.
> Summerizing the chages below:
> Move prepare_transfer_hardware to probe
> Fix the unbind failure
> Add Spinlock
> Use readl/writel() instead of _relaxed()
> Remove __func__ in dev_err
> Declare register variables as u32
> Don't initialize variables and then overwrite them
> Remove unused step
> Remove IRQ entry in geni struct
> Remove extra paranthesis
> Reframe probe errors
> Change the tx_fifo_width naming in handle_rx and handle_tx
> Declare spi_geni_master as 'mas' in complete driver.
> Correcting the punctuation in the comments.
> Adding comments in the code while setting Tx WaterMark Register.
> get_spi_clk_cfg() fixes
> Rewrite the geni_spi_handle_tx() and geni_spi_handle_rx()
> Regarding the suspend/resume and loopback failures, i am working to update in next patch series
> drivers/spi/Kconfig | 12 +
> drivers/spi/Makefile | 1 +
> drivers/spi/spi-geni-qcom.c | 653 ++++++++++++++++++++++++++++++++++++++
> include/linux/spi/spi-geni-qcom.h | 14 +
> 4 files changed, 680 insertions(+)

I've confirmed that all the feedback I'm aware of from previous
versions of this patch has now been addressed, except as noted above:

* suspend callback still looks a little wonky.
* loopback doesn't actually work

IMO it would be OK to land this patch and address the suspend callback
/ loopback issues in later patches, but obviously that's for Mark to

NOTE: for this patch to land it must be based on a tree that includes
the patch ("soc: qcom: geni: Make version macros simpler") [1] in
order to compile. It would also be nice if it was also based upon the
patches ("soc: qcom: geni: Don't ignore clk_round_rate() errors in
geni_se_clk_tbl_get()") [2] and ("soc: qcom: geni:
geni_se_clk_freq_match() should always accept multiples") [3]. Those
aren't needed for things to compile but are technically needed for
correctness. +Andy Gross has said he'll put that the above 3 patches
in his tree in a way that it would be easy to pull in

Mark: it would be super if you had a chance to take a look at this
patch now and see what you think.


With all that said, I'm happy adding:

Reviewed-by: Douglas Anderson <>
Tested-by: Douglas Anderson <>


 \ /
  Last update: 2018-09-18 22:13    [W:0.060 / U:5.700 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site