lkml.org 
[lkml]   [2018]   [Sep]   [18]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH V4 1/4] dt-bindings: soc: qcom: Remove SPI controller maximum frequency binding
Date
SPI controller driver should maintain the maximum frequency
of the controller instead of relying on device tree bindings.
Because maximum frequency is specific property of SPI
controller.

Signed-off-by: Dilip Kota <dkota@codeaurora.org>
---
Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt | 2 --
1 file changed, 2 deletions(-)

diff --git a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
index 68b7d62..16467ed 100644
--- a/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
+++ b/Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.txt
@@ -60,7 +60,6 @@ Required properties:
- interrupts: Must contain SPI controller interrupts.
- clock-names: Must contain "se".
- clocks: Serial engine core clock needed by the device.
-- spi-max-frequency: Specifies maximum SPI clock frequency, units - Hz.
- #address-cells: Must be <1> to define a chip select address on
the SPI bus.
- #size-cells: Must be <0>.
@@ -112,7 +111,6 @@ Example:
pinctrl-names = "default", "sleep";
pinctrl-0 = <&qup_1_spi_2_active>;
pinctrl-1 = <&qup_1_spi_2_sleep>;
- spi-max-frequency = <19200000>;
#address-cells = <1>;
#size-cells = <0>;
};
--
Qualcomm Datacenter Technologies as an affiliate of Qualcomm Technologies, Inc.
Qualcomm Technologies, Inc. is a member of the
Code Aurora Forum, a Linux Foundation Collaborative Project.
\
 
 \ /
  Last update: 2018-09-18 20:09    [W:0.103 / U:3.936 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site