[lkml]   [2018]   [Aug]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v8 09/26] kernel/cpu_pm: Manage runtime PM in the idle path for CPUs
On Wed, Aug 08 2018 at 04:56 -0600, Lorenzo Pieralisi wrote:
>On Mon, Aug 06, 2018 at 11:37:55AM +0200, Rafael J. Wysocki wrote:
>> On Fri, Aug 3, 2018 at 1:42 PM, Ulf Hansson <> wrote:
>> > [...]
>> >
>> >>>
>> >>> Assuming that I have got that right, there are concerns, mostly regarding
>> >>> patch [07/26], but I will reply to that directly.
>> >>
>> >> Well, I haven't got that right, so never mind.
>> >>
>> >> There are a few minor things to address, but apart from that the general
>> >> genpd patches look ready.
>> >
>> > Alright, thanks!
>> >
>> > I will re-spin the series and post a new version once 4.19 rc1 is out.
>> > Hopefully we can queue it up early in next cycle to get it tested in
>> > next for a while.
>> >
>> >>
>> >>> The $subject patch is fine by me by itself, but it obviously depends on the
>> >>> previous ones. Patches [01-02/26] are fine too, but they don't seem to be
>> >>> particularly useful without the rest of the series.
>> >>>
>> >>> As far as patches [10-26/26] go, I'd like to see some review comments and/or
>> >>> tags from the people with vested interest in there, in particular from Daniel
>> >>> on patch [12/26] and from Sudeep on the PSCI ones.
>> >>
>> >> But this still holds.
>> >
>> > Actually, patch 10 and patch11 is ready to go as well. I ping Daniel
>> > on patch 12.
>> >
>> > In regards to the rest of the series, some of the PSCI/ARM changes
>> > have been reviewed by Mark Rutland, however several changes have not
>> > been acked.
>> >
>> > On the other hand, one can also interpret the long silence in regards
>> > to PSCI/ARM changes as they are good to go. :-)
>> Well, in that case giving an ACK to them should not be an issue for
>> the people with a vested interest I suppose.
>Apologies to everyone for the delay in replying.
>Side note: cpu_pm_enter()/exit() are also called through syscore ops in
>s2RAM/IDLE, you know that but I just wanted to mention it to compound
>the discussion.
>As for PSCI patches I do not personally think PSCI OSI enablement is
>beneficial (and my position has always been the same since PSCI OSI was
>added to the specification, I am not even talking about this patchset)
>and Arm Trusted Firmware does not currently support it for the same
>We (if Mark and Sudeep agree) will enable PSCI OSI if and when we have a
>definitive and constructive answer to *why* we have to do that that is
>not a dogmatic "the kernel knows better" but rather a comprehensive
>power benchmark evaluation - I thought that was the agreement reached
>at OSPM but apparently I was mistaken.
I will not speak to any comparison of benchmarks between OSI and PC.
AFAIK, there are no platforms supporting both.

But, the OSI feature is critical for QCOM mobile platforms. The
last man activities during cpuidle save quite a lot of power. Powering
off the clocks, busses, regulators and even the oscillator is very
important to have a reasonable battery life when using the phone.
Platform coordinated approach falls quite short of the needs of a
powerful processor with a desired battery efficiency.

-- Lina

>As a reminder - PSCI firmware implementation has to have state machines
>and locking to guarantee safe power down operations (and to flush caches
>only if necessary - which requires cpu masks for power domains) and
>that's true whether we enable PSCI OSI or not, the coordination logic
>must be in firmware/hardware _already_ - the cpumasks, the power domain
>topology, etc.
>I agree with the power-domains representation of idle-states (since
>that's the correct HW description) and I thought and hoped that runtime
>PM could help _remove_ the CPU PM notifiers (by making the notifiers
>callbacks a runtime PM one) even though I have to say that's quite
>complex, given that only few (ie one instance :)) CPU PM notifiers
>callbacks are backed by a struct device (eg an ARM PMU is a device but
>for instance the GIC is not a device so its save/restore code I am not
>sure it can be implemented with runtime PM callbacks).

 \ /
  Last update: 2018-08-08 20:03    [W:0.102 / U:4.128 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site