[lkml]   [2018]   [Aug]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v3 3/8] mailbox: Add transmit done by blocking option

On 08/08/2018 05:10 PM, Jassi Brar wrote:
> On Wed, Aug 8, 2018 at 5:08 PM, Mikko Perttunen <> wrote:
>> On 04.08.2018 13:45, Mikko Perttunen wrote:
>>> On 08/03/2018 03:54 PM, Jassi Brar wrote:
>>>> On Mon, Jul 2, 2018 at 5:10 PM, Mikko Perttunen <>
>>>> wrote:
>>>>> Add a new TXDONE option, TXDONE_BY_BLOCK. With this option, the
>>>>> send_data function of the mailbox driver is expected to block until
>>>>> the message has been sent. The new option is used with the Tegra
>>>>> Combined UART driver to minimize unnecessary overhead when transmitting
>>>>> data.
>>>> 1) TXDONE_BY_BLOCK flag :-
>>>> Have you tried setting the flag mbox_chan->mbox_client->tx_block
>>>> ?
>>> No - I suppose I should have done that. I'm a bit concerned about overhead
>>> as send_data may be called thousands of times per second, so I tried to make
>>> it as close as possible to the downstream driver that just pokes the mailbox
>>> register directly.
>> I tried using polling in the mailbox framework. Some printing is done from
>> atomic context so it seems tx_block cannot be used -
>> wait_for_completion_timeout understandably does not work in atomic context.
>> I also tried without tx_block, in which case I got some horribly garbled
>> output, but "Try increasing MBOX_TX_QUEUE_LEN" was readable there.
>> Any opinions?
> The problems arise because your hardware (SM) supports TXDONE_BY_POLL,
> but your client drives it by TXDONE_BY_ACK because the older DB
> channels are so.
> Please populate SM channels as a separate controller than DB.
> The DB controller, as is, run by ACK method.
> The SM controller should be run by polling, i.e, set txdone_poll =
> true and the poll period small enough. The virtual tty client driver
> should be able to safely set tx_block from appropriate context.

Sorry, I should have clarified that I already split up the controllers.
The SM controller has txdone_poll = true. I didn't adjust txpoll_period
so I guess it's zero.


 \ /
  Last update: 2018-08-08 16:34    [W:0.219 / U:0.472 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site