lkml.org 
[lkml]   [2018]   [Aug]   [8]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: framebuffer corruption due to overlapping stp instructions on arm64
On Wed, Aug 08, 2018 at 10:12:27AM -0400, Mikulas Patocka wrote:
> On Wed, 8 Aug 2018, Catalin Marinas wrote:
> > On Fri, Aug 03, 2018 at 01:09:02PM -0400, Mikulas Patocka wrote:
> > > while (1) {
> > > start = (unsigned)random() % (LEN + 1);
> > > end = (unsigned)random() % (LEN + 1);
> > > if (start > end)
> > > continue;
> > > for (i = start; i < end; i++)
> > > data[i] = val++;
> > > memcpy(map + start, data + start, end - start);
> > > if (memcmp(map, data, LEN)) {
> >
> > It may be worth trying to do a memcmp(map+start, data+start, end-start)
> > here to see whether the hazard logic fails when the writes are unaligned
> > but the reads are not.
> >
> > This problem may as well appear if you do byte writes and read longs
> > back (and I consider this a hardware problem on this specific board).
>
> I triad to insert usleep(10000) between the memcpy and memcmp, but the
> same corruption occurs. So, it can't be read-after-write hazard. It is
> caused by the improper handling of hazard between the overlapping writes
> inside memcpy.

It could get it wrong between subsequent writes to the same 64-bit range
(e.g. the address & ~63 is the same but the data strobes for which bytes
to write are different). If it somehow thinks that it's a
write-after-write hazard even though the strobes are different, it could
cancel one of the writes.

It may be worth trying with a byte-only memcpy() function while keeping
the default memcmp().

--
Catalin

\
 
 \ /
  Last update: 2018-08-08 16:29    [W:0.142 / U:0.240 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site