[lkml]   [2018]   [Aug]   [6]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v3 3/8] drm/fb_helper: Introduce hotplug_suspend/resume()
On Mon, Aug 06, 2018 at 03:15:31PM -0400, Lyude Paul wrote:
> You did mention in the review of one of my other patches that we should avoid
> disabling polling during runtime suspend, and you're definitely right. I feel
> a bit silly for not remembering that since I was the one who made it so that
> i915 does polling in runtime suspend for chips without RPM HPD detection in
> the first place because it was causing people's displays not to come up on
> vlv...
> Anyway: I think if we just leave output polling enabled during runtime suspend
> that might actually fix all of the fb_helper locking issues since we won't
> need to wait on any of the output poll workers to finish, at least I think it
> should: I'll confirm this when I get into the office

Quoth Imre Deak:

"In i915 polling is on during runtime suspend only if there are outputs
without hotplug interrupt support. A special case is when an output has
working HPD interrupts when in D0, but no interrupts when runtime
suspended. For these we start polling (from a scheduled work) in the
runtime suspend hook and stop it in the runtime resume hook (again from
a scheduled work)."

nouveau only uses runtime PM on discrete GPUs in dual GPU laptops.
Resuming the GPU from D3cold to D0 every few seconds to poll the
outputs would waste too much power on such machines.

The question is, why is polling running at all, since all modern
laptops have HPD-capable ports such as DP?



 \ /
  Last update: 2018-08-06 21:35    [W:0.079 / U:1.824 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site