lkml.org 
[lkml]   [2018]   [Jul]   [9]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH v6 2/8] dt-bindings: Introduce interconnect provider bindings
Date
This binding is intended to represent the interconnect hardware present
in some of the modern SoCs. Currently it consists only of a binding for
the interconnect hardware devices (provider).

Signed-off-by: Georgi Djakov <georgi.djakov@linaro.org>
---
.../bindings/interconnect/interconnect.txt | 33 +++++++++++++++++++
1 file changed, 33 insertions(+)
create mode 100644 Documentation/devicetree/bindings/interconnect/interconnect.txt

diff --git a/Documentation/devicetree/bindings/interconnect/interconnect.txt b/Documentation/devicetree/bindings/interconnect/interconnect.txt
new file mode 100644
index 000000000000..6e2b2971b094
--- /dev/null
+++ b/Documentation/devicetree/bindings/interconnect/interconnect.txt
@@ -0,0 +1,33 @@
+Interconnect Provider Device Tree Bindings
+=========================================
+
+The purpose of this document is to define a common set of generic interconnect
+providers/consumers properties.
+
+
+= interconnect providers =
+
+The interconnect provider binding is intended to represent the interconnect
+controllers in the system. Each provider registers a set of interconnect
+nodes, which expose the interconnect related capabilities of the interconnect
+to consumer drivers. These capabilities can be throughput, latency, priority
+etc. The consumer drivers set constraints on interconnect path (or endpoints)
+depending on the use case. Interconnect providers can also be interconnect
+consumers, such as in the case where two network-on-chip fabrics interface
+directly
+
+Required properties:
+- compatible : contains the interconnect provider compatible string
+- #interconnect-cells : number of cells in a interconnect specifier needed to
+ encode the interconnect node id
+
+Example:
+
+ snoc: snoc@580000 {
+ compatible = "qcom,msm8916-snoc";
+ #interconnect-cells = <1>;
+ reg = <0x580000 0x14000>;
+ clock-names = "bus_clk", "bus_a_clk";
+ clocks = <&rpmcc RPM_SMD_SNOC_CLK>,
+ <&rpmcc RPM_SMD_SNOC_A_CLK>;
+ };
\
 
 \ /
  Last update: 2018-07-09 17:56    [W:0.221 / U:1.260 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site