lkml.org 
[lkml]   [2018]   [Jul]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v18 6/7] crypto: caam: cleanup CONFIG_64BIT ifdefs when using io{read|write}64
Date
On 7/4/2018 6:06 PM, Fabio Estevam wrote:
> Hi Horia,
>
> On Wed, Jul 4, 2018 at 8:45 AM, Horia Geanta <horia.geanta@nxp.com> wrote:
>
>> I think there are two separate issues here:
>>
>> 1. Semantics of operations in io-64-nonatomic-lo-hi.h, io-64-nonatomic-hi-lo.h
>>
>> Logan, you mentioned the following (which unfortunately I somehow missed):
>> https://lore.kernel.org/lkml/c3f2e061-5ed1-5c74-b955-3d2bfb0da074@deltatee.com
>> The lo_hi/hi_lo functions seem to always refer to the data being written
>> or read not to the address operated on.
>>
>> OTOH, initial commit that added asm-generic/io-64-nonatomic-lo-hi.h and
>> asm-generic/io-64-nonatomic-hi-lo.h mentions:
>> 797a796a13df6 ("asm-generic: architecture independent readq/writeq for 32bit
>> environment")
>> - <asm-generic/io-64-nonatomic-lo-hi.h> provides non-atomic readq/ writeq with
>> the order of lower address -> higher address
>> - <asm-generic/io-64-nonatomic-hi-lo.h> provides non-atomic readq/ writeq with
>> reversed order
>>
>> I think we should keep the initial semantics when adding support for
>> io{read|write}64, i.e. "lo" and "hi" to refer to address and not to value.
>>
>> Actually this is the semantics intended for the CAAM patch, see the note at the
>> end of the commit message that refers to addresses, not values:
>> To be consistent with CAAM engine HW spec: in case of 64-bit registers,
>> irrespective of device endianness, the lower address should be read from
>> / written to first, followed by the upper address.
>>
>>
>> 2. CAAM driver I/O accessors for i.MX case
>>
>> CAAM block in some i.MX parts has broken endianness for 64b registers.
>> For e.g. for i.MX6S/SL/D/Q even though CAAM is little endian, BARs for I/O rings
>> have to be programmed as:
>> I/O Ring BAR+0: unused
>> I/O Ring BAR+4: IOVA (32-bit little endian)
>> when the proper layout (for a 64b register) would have been to program IOVA at
>> BAR+0.
>>
>> This explains why I/O accessors in CAAM driver handle things differently in case
>> caam_imx=true.
>>
>> Since this quirk cannot be accommodated in generic fashion, code dealing with
>> caam_imx has to stay.
>
> Should I sent a revert of patch 46e4bf08f6388 for the boot regression for now?
>
> Then the two issues you pointed out could be fixed later.
>
I guess it would be better this way.

Thanks,
Horia

\
 
 \ /
  Last update: 2018-07-04 18:00    [W:0.111 / U:3.228 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site