lkml.org 
[lkml]   [2018]   [Jul]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
Patch in this message
/
From
Subject[PATCH] dt-bindings: thermal: qcom-spmi-temp-alarm: Fix documentation of 'reg'
Date
The documentation claims that the 'reg' property consists of two values,
the SPMI address and the length of the controller's registers. However
the SPMI bus to which it is added specifies "#size-cells = <0>;". Remove
the controller register length from the documentation of the field and the
example.

Signed-off-by: Matthias Kaehlcke <mka@chromium.org>
---
.../devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt | 5 ++---
1 file changed, 2 insertions(+), 3 deletions(-)

diff --git a/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt b/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
index 290ec06fa33a..86fb41fe772f 100644
--- a/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
+++ b/Documentation/devicetree/bindings/thermal/qcom-spmi-temp-alarm.txt
@@ -6,8 +6,7 @@ interrupt signal and status register to identify high PMIC die temperature.

Required properties:
- compatible: Should contain "qcom,spmi-temp-alarm".
-- reg: Specifies the SPMI address and length of the controller's
- registers.
+- reg: Specifies the SPMI address.
- interrupts: PMIC temperature alarm interrupt.
- #thermal-sensor-cells: Should be 0. See thermal.txt for a description.

@@ -20,7 +19,7 @@ Example:

pm8941_temp: thermal-alarm@2400 {
compatible = "qcom,spmi-temp-alarm";
- reg = <0x2400 0x100>;
+ reg = <0x2400>;
interrupts = <0 0x24 0 IRQ_TYPE_EDGE_RISING>;
#thermal-sensor-cells = <0>;

--
2.18.0.233.g985f88cf7e-goog
\
 
 \ /
  Last update: 2018-07-25 01:52    [W:0.042 / U:2.288 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site