lkml.org 
[lkml]   [2018]   [Jul]   [23]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Subject[PATCH v3 0/3] add memcpy support for sdma
Date
This patchset is to add memcpy interface for imx-sdma, besides,to
support dmatest and enable config by default, so that could test dma
easily without any other device support such as uart/audio/spi...

Change from v2:
1. remove 'copy_align' since sdma script for memory_2_memory will handle
such align issue. No such align limitation. Also remove bus width
description in bd.
2. for multi bds case such as in dmatest, should make sure all bds of
single transfer should be consistent, so enlarge allocated size for
dma pool to max bds, 20 bds/1.28MB should be enough for all case.Report
error if the bd number exceed 20.

Change from v1:
1. remove bus_width check for memcpy since only max bus width needed for
memcpy case to speedup copy.
2. remove DMATEST support patch, since DMATEST is a common memcpy case.
3. split to single patch for SDMA_BD_MAX_CNT instead of '0xffff'
4. move sdma_config_ownership() from alloc_chan into sdma_prep_memcpy.
5. address some minor review comments.

Robin Gong (3):
dmaengine: imx-sdma: add SDMA_BD_MAX_CNT to replace '0xffff'
dmaengine: imx-sdma: add memcpy interface
dmaengine: imx-sdma: allocate max 20 bds for one transfer

drivers/dma/imx-sdma.c | 121 +++++++++++++++++++++++++++++++++++++++++++++----
1 file changed, 112 insertions(+), 9 deletions(-)

--
2.7.4

\
 
 \ /
  Last update: 2018-07-23 11:45    [W:0.125 / U:1.748 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site