lkml.org 
[lkml]   [2018]   [Jun]   [27]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v10 4/7] i2c: fsi: Add abort and hardware reset procedures
From
Date


On 06/25/2018 09:38 PM, Wolfram Sang wrote:
> On Wed, Jun 13, 2018 at 02:36:16PM -0500, Eddie James wrote:
>> Add abort procedure for failed transfers. Add engine and bus reset
>> procedures to recover from as many faults as possible.
> I think this is a way too aggressive recovery. Your are doing the 9
> pulse toggles basically on any error while this is only when the device
> keeps SDA low and you want to recover from that. If SDA is not stuck
> low, sending a STOP should do. Or do you have a known case where this is
> not going to work?

It is aggressive, but I don't see the harm in doing this on every error.
There are some other error conditions with this hardware which may
require the clock toggling, such as "bus arbitration lost." I think this
is the safest option for this hardware, and this routine has been tested
for many years.

>
> Also, you implement the pulse toggling manually. Can't you just populate
> {get|set}_{scl|sda} and use the generic routine we have in the core?

I see that the generic implementation breaks the loop if it sees the
clock isn't high after setting it, or if SDA goes high. I think it's
safer to finish the reset for our hardware. Plus, we actually have
different registers for setting 0 or 1 to the clock/data, so we save
some cpu cycles by doing it directly instead of implementing set_scl/sda
and having to check val every time :)

If you feel very strongly that this recovery procedure needs to be
reduced, then I will work on that and have to do some extensive testing.

Thanks!
Eddie

>

\
 
 \ /
  Last update: 2018-06-27 15:49    [W:0.046 / U:4.056 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site