lkml.org 
[lkml]   [2018]   [Jun]   [25]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
Date
From
SubjectRe: [PATCH v10 4/7] i2c: fsi: Add abort and hardware reset procedures
On Wed, Jun 13, 2018 at 02:36:16PM -0500, Eddie James wrote:
> Add abort procedure for failed transfers. Add engine and bus reset
> procedures to recover from as many faults as possible.

I think this is a way too aggressive recovery. Your are doing the 9
pulse toggles basically on any error while this is only when the device
keeps SDA low and you want to recover from that. If SDA is not stuck
low, sending a STOP should do. Or do you have a known case where this is
not going to work?

Also, you implement the pulse toggling manually. Can't you just populate
{get|set}_{scl|sda} and use the generic routine we have in the core?

\
 
 \ /
  Last update: 2018-06-26 04:38    [W:0.175 / U:0.664 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site