[lkml]   [2018]   [Jun]   [24]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: Finish the GENERIC_IRQ_MULTI_HANDLER conversion
On Thu, 21 Jun 2018, Palmer Dabbelt wrote:
> A while ago I sent a patch set that adds a GENERIC_IRQ_MULTI_HANDLER,
> which is an exact copy of the existing IRQ_MULTI_HANDLER support in the
> arm port, which is being used unconditionally by arm64 and openrisc.
> GENERIC_IRQ_MULTI_HANDLER is currently being used by the RISC-V port. I
> managed to make a few mistakes in my original patch set and as a result
> my conversion of the other architectures of GENERIC_IRQ_MULTI_HANDLER
> was dropped.
> This patch set finishes up my original patch set by converting arm,
> arm64, and openrisc over to the new GENERIC_IRQ_MULTI_HANDLER support
> and then removing MULTI_IRQ_HANDLER as it's obselete.
> At the time I wrote this I gave it fairly extensive build testing, but
> went I recently rebased it I just tested the full patch set on arm,
> arm64, and openrisc defconfigs.
> Various flavors of this patch set have bounced around a few times
> before, but I'm calling this a whole new patch set as it builds on top
> of what was merged.

I'll take the whole pile through tip irq/core which probably makes the most
sense unless there are any objections from architecture maintainers.



 \ /
  Last update: 2018-06-24 15:16    [W:0.077 / U:3.612 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site