lkml.org 
[lkml]   [2018]   [Jun]   [12]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
Date
SubjectRe: [PATCH] arm64: dts: stingray: use NUM_SATA to configure number of sata ports
On Thu, Jun 7, 2018 at 12:53 PM, Scott Branden
<scott.branden@broadcom.com> wrote:
> Hi Rob,
>
> Could you please kindly comment on change below.
>
> It allows board variants to be added easily via a simple define for
> different number of SATA ports.
>
>
>
> On 18-06-04 09:22 AM, Florian Fainelli wrote:
>>
>> On 05/18/2018 11:34 AM, Scott Branden wrote:
>>>
>>> Move remaining sata configuration to stingray-sata.dtsi and enable
>>> ports based on NUM_SATA defined.
>>> Now, all that needs to be done is define NUM_SATA per board.
>>
>> Rob could you review this and let us know if this approach is okay or
>> not? Thank you!
>>
>>> Signed-off-by: Scott Branden <scott.branden@broadcom.com>
>>> ---

>>> diff --git a/arch/arm64/boot/dts/broadcom/stingray/stingray-sata.dtsi
>>> b/arch/arm64/boot/dts/broadcom/stingray/stingray-sata.dtsi
>>> index 8c68e0c..7f6d176 100644
>>> --- a/arch/arm64/boot/dts/broadcom/stingray/stingray-sata.dtsi
>>> +++ b/arch/arm64/boot/dts/broadcom/stingray/stingray-sata.dtsi
>>> @@ -43,7 +43,11 @@
>>> interrupts = <GIC_SPI 321 IRQ_TYPE_LEVEL_HIGH>;
>>> #address-cells = <1>;
>>> #size-cells = <0>;
>>> +#if (NUM_SATA > 0)
>>> + status = "okay";
>>> +#else
>>> status = "disabled";
>>> +#endif

This only works if ports are contiguously enabled (0-N). You might not
care, but it is not a pattern that works in general. And I'm not a fan
of C preprocessing in DT files in general beyond just defines for
single numbers.

Rob

\
 
 \ /
  Last update: 2018-06-13 00:55    [W:0.061 / U:3.804 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site