lkml.org 
[lkml]   [2018]   [May]   [4]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
From
SubjectRe: [PATCH v6 3/3] clk: qcom: Add Global Clock controller (GCC) driver for SDM845
Date
Quoting Amit Nischal (2018-05-04 03:45:12)
> On 2018-05-02 12:53, Stephen Boyd wrote:
> > Quoting Amit Nischal (2018-04-30 09:20:10)
> >> +
> >> +static struct clk_branch gcc_disp_gpll0_clk_src = {
> >> + .halt_reg = 0x52004,
> >> + .halt_check = BRANCH_HALT_DELAY,
> >
> > What about this one? It's not a phy so I'm confused again why we're
> > unable to check the halt bit. To be clear(er), I don't see why we ever
> > want to have HALT_DELAY used. Hopefully we can remove that flag.
> >
> > From what I recall, the flag is there for clks that don't toggle their
> > status bit at all, but that we know take a few cycles to ungate the
> > upstream clk. So we threw a delay into the code to make sure that when
> > clk_enable() returned, a driver wouldn't try to use hardware before the
> > clk was actually on. But these cases should pretty much never happen,
> > hence all the pushback against this flag.
> >
>
> For these "*gpll0_clk_src" and "*gpll0_div_clk" clocks, there is no halt
> bit to check the status and it is required to have delay for few cycles
> so that clock gets turned on before a client driver to use the hardware.

Ok.. but then why is there a 'halt_reg' configured for the clk?

> >> +
> >> +static struct clk_branch gcc_ufs_card_rx_symbol_0_clk = {
> >> + .halt_reg = 0x75018,
> >> + .halt_check = BRANCH_HALT_DELAY,
> >
> > There are still HALT_DELAY flags for UFS though? Why?
>
> For ufs_card tx/rx symbol clocks, we don't poll the status bit as
> per the recommendation from the HW team. We can change the halt_check
> type to newly implemented flag "BRANCH_HALT_SKIP". Please update us with
> your thoughts to change the flag to "BRANCH_HALT_SKIP".

Yes use HALT_SKIP please.

>
> >
> > Also, are you going to send DFS support for the QUP clks? I would like
> > to see that code merged soon.
>
> Taniya has sent the patches for DFS support for QUP clocks.
> https://patchwork.kernel.org/patch/10376951/
>

I'll take a look.

\
 
 \ /
  Last update: 2018-05-05 05:14    [W:0.050 / U:1.200 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site