[lkml]   [2018]   [May]   [31]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
SubjectRe: [PATCH v4 3/6] regulator: bd71837: Devicetree bindings for BD71837 regulators
On Wed, May 30, 2018 at 10:04:36PM -0500, Rob Herring wrote:
> On Wed, May 30, 2018 at 11:42:32AM +0300, Matti Vaittinen wrote:
> > Document devicetree bindings for ROHM BD71837 PMIC regulators.
> > +ROHM BD71837 Power Management Integrated Circuit (PMIC) regulator bindings
> > +
> > +BD71837MWV is a programmable Power Management
> > +IC (PMIC) for powering single-core, dual-core, and
> > +quad-core SoC’s such as NXP-i.MX 8M. It is optimized
> > +for low BOM cost and compact solution footprint. It
> > +integrates 8 Buck regulators and 7 LDO’s to provide all
> > +the power rails required by the SoC and the commonly
> > +used peripherals.
> Why duplicate this from the core binding?

I can remove this. I just thought it is nice to see what this chip is
doing even without opening the MFD binding doc. Just same question as in
the other patch - how should I deliver the change? This was already
applied to Mark's tree - should I do new patch on top of the Mark's tree
- or do patch against tree which does not yet contain this change? If I
do it on top of Mark's tree then Mark should apply it, right? If I do
it against some other three, thene there will be merge conflict with
Mark, right?

> Otherwise,
> Reviewed-by: Rob Herring <>


Matti Vaittinen

 \ /
  Last update: 2018-05-31 09:22    [W:0.054 / U:1.768 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site