lkml.org 
[lkml]   [2018]   [May]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
 
Messages in this thread
/
SubjectRe: [PATCH v4 6/6] tty/serial: atmel: changed the driver to work under at91-usart mfd
From
Date


On 05/28/2018 01:08 PM, Richard Genoud wrote:
> On 25/05/2018 19:19, Radu Pirea wrote:
>> This patch modifies the place where resources and device tree properties
>> are searched.
>>
>> Signed-off-by: Radu Pirea <radu.pirea@microchip.com>
>> ---
>> drivers/tty/serial/Kconfig | 1 +
>> drivers/tty/serial/atmel_serial.c | 40 +++++++++++++++++--------------
>> 2 files changed, 23 insertions(+), 18 deletions(-)
> the stdout-path property of the chosen node is still broken in this verion.
> if :
> stdout-path = "serial0:115200n8";
> is set in the DTS, the console output should go on serial0 (aka dbgu)
> cf Documentation/devicetree/bindings/chosen.txt
>
> With this patch applied, this is not the case anymore.
> Adding console=ttyS0,115200 in the chosen node is not the solution here.
>

I fixed the issue few minutes ago :)

I hope DMA setup is ok now.

>
> regards,
> Richard.
>

\
 
 \ /
  Last update: 2018-05-29 11:14    [W:0.060 / U:2.788 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site