[lkml]   [2018]   [May]   [29]   [last100]   RSS Feed
Views: [wrap][no wrap]   [headers]  [forward] 
Messages in this thread
Subject[PATCH v7 0/7] i2c: Add FSI-attached I2C master algorithm
This series adds an algorithm for an I2C master physically located on an FSI
slave device. The I2C master has multiple ports, each of which may be connected
to an I2C slave. Access to the I2C master registers is achieved over FSI bus.

Due to the multi-port nature of the I2C master, the driver instantiates a new
I2C adapter for each port connected to a slave. The connected ports should be
defined in the device tree under the I2C master device.

Changes since v6
- Remove spinlock for reset functionality; it's unecessary and doesn't work
with the latest FSI core.
- Use a mutex instead of a semaphore, and don't wait for timeout to get the
- Use usleeps instead of schedule_timeout; it's not worth the overhead when
the wait should be very short in between sending the command and receiving
the response.

Changes since v5
- Fix reset functionality and do a reset after every transfer failure

Edward A. James (7):
dt-bindings: i2c: Add FSI-attached I2C master dt binding documentation
drivers/i2c: Add FSI-attached I2C master algorithm
drivers/i2c: Add port structure to FSI algorithm
drivers/i2c: Add abort and hardware reset procedures
drivers/i2c: Add transfer implementation for FSI algorithm
drivers/i2c: Add I2C master locking to FSI algorithm
drivers/i2c: Add bus recovery for FSI algorithm

Documentation/devicetree/bindings/i2c/i2c-fsi.txt | 40 ++
drivers/i2c/busses/Kconfig | 11 +
drivers/i2c/busses/Makefile | 1 +
drivers/i2c/busses/i2c-fsi.c | 738 ++++++++++++++++++++++
4 files changed, 790 insertions(+)
create mode 100644 Documentation/devicetree/bindings/i2c/i2c-fsi.txt
create mode 100644 drivers/i2c/busses/i2c-fsi.c


 \ /
  Last update: 2018-05-30 00:26    [W:0.108 / U:5.232 seconds]
©2003-2020 Jasper Spaans|hosted at Digital Ocean and TransIP|Read the blog|Advertise on this site